1234
1. SERVICE PRECAUTIONS
1.1 NOTES ON SOLDERING
ANOTES ON SOLDERING
Y For environmental protection, lead-free solder is used on the printed circuit boards mounted in this unit.
Be sure to use lead-free solder and a soldering iron that can meet specifications for use with lead-free solders for repairs
accompanied by reworking of soldering.
Y Compared with conventional eutectic solders, lead-free solders have higher melting points, by approximately 40 1C.
Therefore, for lead-free soldering, the tip temperature of a soldering iron must be set to around 373 1C in general, although
the temperature depends on the heat capacity of the PC board on which reworking is required and the weight of the tip of
the soldering iron.
Do NOT use a soldering iron whose tip temperature cannot be controlled.
B
Compared with eutectic solders, lead-free solders have higher bond strengths but slower wetting times and higher melting
temperatures (hard to melt/easy to harden).
The following lead-free solders are available as service parts:
Y Parts numbers of lead-free solder:
GYP1006 1.0 in dia.
GYP1007 0.6 in dia.
GYP1008 0.3 in dia.
1.2 WHEN REPLACING DVD DECK
C
WHEN REPLACING DVD DECK
[ Removing the DVD Deck ]
Before removing Pick Up PCB and DVD PCB connector, short circuit the position shown in Fig. 1 using
a soldering iron. If you remove the DVD Deck with no soldering, the Laser may be damaged.
[ Installing the DVD Deck ]
Remove all the soldering on the short circuit position after the connection of Pick Up PCB and DVD
PCB connector.
D
NOTE
Y Before your operation, please read OPREPARATION OF SERVICING� .
Y Use the Lead Free solder.
Y Manual soldering conditions
Y Soldering temperature: 320 ? 20uC
Y Soldering time: Within 3 seconds
Y Soldering combination: Sn-3.0Ag-0.5Cu
Y When Soldering/Removing of solder, use the draw in equipment over the Pick Up Unit to prevent the
Flux smoke from it.
E
Short circuit using a
soldering iron.
Pick Up PCB
F
Fig. 1
6DV-400V-S
1234 |
ACEC
