5678
7.1.7 AGING MODE
Notes:
Commands from the remote control unit are accepted during Aging mode.
If Aging mode is quit using the ESC key, indications on the FL display will return to normal dislay.
A
Cancel timer settings before entering Aging mode.
Set the recording rate beforehand. It cannot be changed during Aging mode.
Aging for the DVD-RWAging for the DVD-R
Press the DVD key to switch to DVD. Install a recordable Press the DVD key to switch to DVD. Install a recordable
To enterDVD-RW disc. After disc detection, press the ESC key then DVD-R disc. After disc detection, press the ESC key then the
the REP.B key on the remote control unit for servicing to enter REP.B key on the remote control unit for servicing to enter
Aging mode
Aging mode.Aging mode.
Press the ESC key on the remote control unit for servicing to Press the ESC key on the remote control unit for servicing to
quit Aging mode and return to Normal mode. This also results quit Aging mode and return to Normal mode. This also results
in the following:in the following:B
Y If during recording: Recording is stopped.Y If during recording: Recording is stopped.
To quitY If during playback: Playback is paused.Y If during playback: Playback is paused.
Aging modeY If during initialization: The unit stops after initialization is
finished.
Y If the tray is being opened/closed: The unit stops after the
tray is opened/closed.
During Aging mode, the following operations are repeated in During Aging mode, the following operations are repeated in
the order shown below.the order shown below.
1 The tray opens.1 The tray opens.
2 The tray closes.2 The tray closes.
3 Initialization3 Recording for 1 minute
4 Recording for 60 minutes4 Recording pause for 6 minutes
5 Playback for 45 minutes5 Recording stops.
C
6 Playback for 1 minute
7 Playback pause for 6 minutes
8 Playback stops.
Note:
A continuous test of the above operations is possible for
approximately 23 hours.
3 Initialization is performed according to the setting specified After 2 the tray closes, disc detection is performed, and if 99
in "DVD-RW automatic initialization" (accessed by selecting titles have already been registered, the unit stops there. The
Function
"Unit Setting" then "Option").number of loops is retained and indicated on the FL display.
An error indication is retained as an OSD.
During Aging, the number of loops is indicated on the FL During Aging, the number of loops is indicated on the FL
display, as shown below.display, as shown below.
[AGING 0001] [AGING 0001]D
If an error is generated, the aging operation stops.If an error is generated, the aging operation stops.
Note:Note:
Indications on the FL display are retained, and this Indications on the FL display are retained, and this
information is also retained as an OSD.information is also retained as an OSD.
Note:
Recording time depends on the recording rate set. For
example, if the recording rate is MN32, only up to 60 titles can
be registered. Check the setting for recording rate before
performing aging.
E
F
89
DVR-220-S
5678 |
ACEC
