5 Disassembly and Reassembly
5-2 Disassembly (CHB5**7L)
Cautions:1. Disconnect the monitor from the power source before disassembly.
2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.
5-2-1 Cabinet Disassembly5-2-3 Removing the Main PCB
1. With a pad beneath it, stand the monitor on its1. Follow steps 1 through 5 in OCabinet
front with the screen facing downward andDisassembly,� steps 1 through 7 in ORemoving
the base close to you. Make sure nothing willthe Video PCB and ORemoving the CRT
damage the screen.Socket PCB,� above.
2. Working from the back of the monitor remove2. Disconnect the Degaussing Coil at CN600 on
the signal cover cap out, and remove the 4the Main PCB.
screws and carefully pull the rear cabinet up
and off the monitor.3. Disconnect all easily accessible ground wires
from the CRT GND Assembly and Bottom
3. Remove the 4 screws on the Top Shield andChassis.
remove it.4. Disconnect the connector between CN_Tilt. on
4.the Main PCB and the Tilt coil.
5. Remove the 4 screws on the Bottom Cover and5. Disconnect the DY connector between the DY
pull it upward to remove it.and the CN300A_7, CN400, CN401 and CN402
connectors on the Main PCB.
6. Using pinch-nosed pliers or long-nosed pliers,
carefully disconnect the Anode Cap from the6.
CRT.7. Remove the 8 screws on the top side of the
Main PCB.
5-2-2 Removing the Video PCB & 8. Lift the Main PCB and place it on a flat, level
CRT Socket PCB
surface that is protected from static electricity.
1. Follow steps 1 through 5 in OCabinet
Disassembly,� above.
2. Disconnect connectors CN103.
3. Lift off the CRT Socket PCB Assembly.
4. Hold the CRT Socket PCB Assembly while
you lift the cap on the CRT Socket and pull
out the two focus wires, G2 wire.
5. Remove both side screws on the lower edge of
the Video PCB AssOy and the screw on the
signal connector and pull the assembly
towards you to remove it.
6. Remove all screws on the Video PCB
Assembly and remove the Video Shield.
7. Lift out the Video PCB and place it on a flat,
level surface that is protected from static
electricity.
5-2CHB5**7L/6**7L/7**7L |
ACEC
