Alignment and Adjustments
4-3-3 High Voltage Check4-3-6 Purity Adjustment
CAUTION: There is no high voltage adjustment on this chassis.1. Warm up the receiver for at least 20 minutes.
The B+ power supply must be set to +130 volts (Full color bar input
and normal picture level).2. Plug in the CRT deflection yoke and tighten
the clamp screw.
1. Connect a digital voltmeter to the second
anode of the picture tube.3. Plug the convergence yoke into the CRT and
set in as shown in Fig. 4-2.
2. Turn on the TV. Set the Brightness and
Contrast controls to minimum (zero beam cur-4. Input a black and white signal.
rent).
5. Fully demagnetize the receiver by applying an
3. The high voltage should not exceed 33KV.external degaussing coil.
4. Adjust the Brightness and contrast controls to6. Turn the CONTRAST and BRIGHTNESS con-
both extremes. Ensure that the high voltagetrols to maximum.
does not exceed 33KV under any conditions.
7. Loosen the clamp screw holding the yoke.
4-3-4 FOCUS AdjustmentSlide the yoke backward or forward to pro-
vide vertical green belt. (Fig. 4-3).
1. Input a black and white signal.
8. Tighten the convergence yoke.
2. Adjust the tuning control for the clearest
picture.9. Slowly move the deflection yoke forward,
and adjust for the best overall green screen.
3. Adjust the FOCUS control for well defined
scanning lines in the center area of the screen.10. Temporarily tighten the deflection yoke.
11. Produce blue and red rasters by adjusting the
4-3-5 Screen Adjustmentlow-light controls. Check for good purity in
1. Connect CRT socket pin GK, BK, RK to aneach field.
oscilloscope probe.12. Tighten the deflection yoke.
2. Input a gray scale pattern. (Use a pattern
generator, PM5518)
3. Use the Picture mode for the STANDARD pic-
ture.
4. Adjust the Screen VR (on the FBT) so that the
voltage on the oscilloscope becomes 130+2.5V_
(See Fig. 4-1).
130 2.5V+_
GND
Fig. 4-1
Samsung Electronics4-7 |
ACEC
