SAFETY PRECAUTION
1: An isolation transformer should be connected in the3: When replacing a chassis in the cabinet, always be
power line between the receiver and the AC linecertain that all the protective devices are installed
when a service is performed on the primary of theproperly, such as, control knobs, adjustment covers
converter transformer of the set.or shields, barriers, isolation resistor-capacitor
2: Comply with all caution and safety-related notesnetworks etc.Before returning any television to the
provided on the cabinet back, inside the cabinet, oncustomer, the service technician must be sure that it
the chassis or the picture tube.is completely safe to operate without danger of
electrical shock.
X-RADIATION PRECAUTION
The primary source of X-RADIATION in the television receiver is the picture tube. The picture tube is specially
constructed to limit X-RADIATION emissions. For continued X-RADIATION protection, the replacement tube must
be the same type as the original including suffix letter. Excessive high voltage may produce potentially hazardous
X-RADIATION. To avoid such hazards, the high voltage must be maintained within specified limit. Refer to this
service manual, high voltage adjustment for specific high voltage limit. If high voltage exceeds specified limits,
take necessary corrective action. Carefully follow the instructions for +B1 volt power supply adjustment, and high
voltage adjustment to maintain the high voltage within the specified limits.
PRODUCT SAFETY NOTICE
Product safety should be considered when a component replacement is made in any area of a receiver.
Components indicated by mark !in the parts list and the schematic diagram designate components in which
safety can be of special significance. It is particularly recommended that only parts designated on the parts list in
this manual be used for component replacement designated by mark !. No deviations from resistance wattage
or voltage ratings may be made for replacement items designated by mark !.
SPECIFICATIONS
Power source AC 220~240V 50Hz
Television SystemB/G, D/K
Colour system PAL/NTSC4.43 on Air
(PAL/NTSC4.43/NTSC3.58 in AV mode)
Channel coverageVHF: E2-E12, R1-R12
UHF: 21-69
CATV: X, Y, Z, S1-S41
Aerial input impedance 75ohm
AV terminals
AV1:CENELEC Standard
Input: Composite video, RGB and audio-L/R
Output: TV-output with composite video and audio-L/R
AV2: CENELEC Standard
Input: Composite video, S-VHS and audio-L/R
Output: Monitor-output with composite video and audio-L/R
Sound output 5.0 x 2
(continuous) (watts)
Picture tubes (Inches)28
Dimensions (WxHxD)736 x 597 x 494 mm
Weight 32 kg
Specifications subject to change without notice.
2
EB6-D chassis |
ACEC
