13L-M100/150
CL13M10/15
14ML10
Sub-Brightness Adjustment3.58MHz Trap Adjustment
1. Receive a good local channel.1. Receive a good local channel.
2. Make sure the customer brightness control is set to2. Enter the service mode and select the service
center position.adjustment "S16".
3. Enter the service mode and select the service3. This is a two position adjustment, "00" is ON, "01" is
adjustment "S04".OFF.
4. Adjust "S04" data value to obtain normal brightness4. Adjust data value to "00" for normal viewing.
level.
Sharpness, Audio Balance, Energy Save
Vertical-Size AdjustmentOffset, DDE Offset, OSD Setup, Tuner
1. Receive a good local channel.Setup and Option Adjustments
2. Enter the service mode and select the service
1. Receive a good local channel.
adjustment "S09".
2. Enter the service mode and select the service
3. While observing the top and bottom of the screen,
adjustments "S05" for sharpness, "S17" for balance,
adjust "S09" data value to proper vertical size.
"S20" for energy save offset, "S21" for DDE offset,
"S22" for OSD setup, "S23" for tuner and "OP" for
Vertical Phase Adjustmentoption.
E Sharpness Adjustment
1. Enter the service mode and select the service
adjustment "S06".3. Adjust data value to "24" (center of data range) for
2. Adjust data value to "00"~"03" so that picture issharpness adjustment.
approximate center.E Audio Balance Adjustment
4. Adjust data value to "20" (center of data range) for
Note:This must be set "00"~"03" when adjust
Audio balance adjustment.
another data retrace line will be appear.
E Energy Save Offset Adjustment
5. Adjust data value to "23".
Horizontal Position Adjustment
E DDE Offset Adjustment
1. Receive a good local channel.6. Adjust data value to "03".
2. Enter the service mode and select the serviceE OSD Setup Adjustment
adjustment "S07".7. Adjust data value to "00".
3. Adjust "S07" data value so that picture is centered.E Tuner Setup Adjustment
8. Adjust data value to "00".
Caption Position Adjustment (Horizontal)E Option Adjustment
9. Adjust data value to "02".
1. Receive a good local channel.
2. Enter the service mode and select the service
adjustment "S18".
3. A black text box appears on the screen. (see Figure
B. below)
4. Adjust "S18" data value so that text box is positioned
in the center of the screen.
Figure B.
11 |
ACEC
