14D2-SS
20D2-SS
21D2-SS
.
.
AGE SYSTEM AND PIC-, perform the following safety Checks.
T2-2
.AC outlet.)
A) in the case of the set.A) in the case of the set.
.A) in the case of the set.??
?Adjusted to the above-mentioned high voltage.
A) for the set.A) for the set.A) for the set.100 100
???
1.5kV(at beam 800 1.5kV(at beam 11.5kV(at beam 1
IMPORTANT SERVICE NOTES???
the high voltage completelythan 25.2kV(at beam 0 20D2-SS : When repairing the circuit, be sure not to increase the high voltage to more than 27.6kV(at beam 0 21D2-SS : When repairing the circuit, be sure not to increase the high voltage to more than 28.0kV(at beam 0 14D2-SS : To keep the set in a normal operation, be sure to make it function on 22.7kV20D2-SS : To keep the set in a normal operation, be sure to make it function on 24.5kV21D2-SS : To keep the set in a normal operation, be sure to make it function on 24.8kVThe set has been factory - * If there is a possibility that the high voltage fluctuates as a result of the repairing, never forget to check for such high voltage after the work.Do not substitute a picture tube with unauthorized types and/or brands which may cause excess X-ray radiation.lodged between the chassis and other metal parts in the receiverInspect all protective devices such as non-metallic control knobs, insulating fishpapers, cabinet backs, adjustment and compartment covers or shields, isolation resistor- ca- pacity networks, mechanical insulators etc.
Maintenance and repairing of this receiver should be done by quali- fied service personnel onlySERVICE OF HIGH VOLTURE TUBEWhen servicing the high voltage system, remove static charge from it by Connecting a 10K ohm Resistor in series with an insulated wire(such as a test probe) between picture tube dag and 2nd anode lead. (AC line cord should be disconnected from 1.Picture tube in this receiver employs integral implosion protection. 2.Replace with tube of the same type number for continued safety3.Do not lift picture tube by the neck. 4.Handle the picture tube only when wearing shatterproof goggles and after dischargingX-RAYThis receiver is designed so that any X-Ray radiation is kept to an absolute Minimum. Since certain malfunctions or servicing may produce potentially hazardous radiation with prolonged exposure at close range, the following precautions should be observed:1.14D2-SS : When repairing the circuit, be sure not to increase the high voltage to more2.3.BEFORE RETURNING THE RECEIVERBefore returning the receiver to the user1.Inspect all lead dress to make certain that leads are not pinched or that hardware is not2.
62W72W79W
Magnetic38.9MHz32.4MHz32.9MHz33.4MHz
34.47MHzAll Plastics
5.0W(at Max.)
Width: 446.0mm Height: 333.0mm Depth: 362.0mmWidth: 594.0mm Height: 465.0mm Depth: 478.5mmWidth: 594.0mm Height: 465.0mm Depth: 473.0mm
16 ohms at 400 Hz
75 ohms Unbalancedeight(approx): 9.2 kg
10 ~ 240V AC 50/60 Hz5 x 9 cm Elliptic (2 pcs)W
1 Weight(approx): 18.0 kg Weight(approx): 21.0 kg
Self Convergence System
AL-B/G,D/K,I SECAM-B/G,D/K,K1
P
Electrostatic Focus High Bi-PotentialE2(48.25MHz) thru E12(224.25MHz)
C1(49.75MHz) thru C12(216.25 MHz) S1(105.25MHz) thru S36(423.25HMz)
E21(471.25MHz) thru E69(855.25MHz) C13(471.25MHz) thru C57(863.25MHz) S37(431.25MHz) thru S41(463.25MHz)
2-1
............................................................
..............................................................
...........................................................
..................................................................................
SPECIFICATIONS................................................................................................................................
Specifications are subject to change without prior notice.
VHF/UHF..........................................................................VHF-Channels
Convergence.................................................................Focus............................................................Sweep DeflectionIntermediate Frequencies Picture IF Carrier Sound IF Carrier Frequency 6.5MHz.............................................................................................. 6.0MHz.............................................................................................. 5.5MHz.............................................................................................. Colour Sub-Carrier FrequencyPower Input.....................................................................Power Consumption 14D2-SS...................................................................................................... 20D2-SS...................................................................................................... 21D2-SS......................................................................................................Audio Power Output RatingSpeaker Size..................................................................... Voice Coil ImpedanceAerial Input Impedance Receiving System...........................................Tuner Ranges UHF-Channels......................................Dimensions 14D2-SS................................................................................... 20D2-SS................................................................................... 21D2-SS...................................................................................Cabinet material....................................................................................
2 |
ACEC
