21HS-50C
ELECTRICAL SPECIFICATIONS
"Power Input ................220V-240 Volts AC 50Hz"Sound Carrier Trap
B/G .......................................... 33.4MHz
"Power Consumption D/K .......................................... 32.4MHz
Normal Operation (Method IEC60107)....43W
"Adjacent Sound Carrier Trap
Stand-by Operation..............................3W
B/G .......................................... 40.4MHz
D/K .......................................... 40.4MHz
"Audio Power Output Rating .........4W x 2(MPO)"Adjacent Picture Carrier Trap
B/G .......................................... 31.9MHz
Speaker.........................16& 4W, 9 x 5 cm,2pcs
D/K .......................................... 30.9MHz
Convergence ................Self Converging System
"Aerial Input Impedance
Focus ..........................Bi-Potential ElectrostaticVHF/UHF ..................75 ohm Unbalanced
Sweep Deflection ... .............................Magnetic
"Tuning Ranges .....48.25MHz thru 855.25 MHz
"Picture Intermediate Frecuency VHF ....CH02-CH12, R01-R12
B/G ......................................... 38.9MHz
S1-S41 (HYPERBAND)
D/K ......................................... 38.9MHz
UHF .....CH21 - CH69
"White Level
Set the brightness control, with no signal connected, so that the CRT cathode current is 600?A. The
maximum correction applied to each cathode current to achieve a screen temperature of 7250 degrees
K-11 MPCD should not exceed 15% of its original value.
XYScreen temperature
0.304 + 0.0150.306 + 0.0157250o K-11 MPCD
Specifications are subject to change without prior notice.
MODEL DESTINATION (Operation Manual languages)
21HS50C: English, Polish, Russian, Czech, Slovak, Hungarian, Romanian.
WARNING
The chassis in this receiver is partially hot. Use an isolation transformer between the line cord plug
and power receptacle, when servicing this chassis.
To prevent electric shock, do not remove cover. No user-serviceable parts inside. Refer servicing to
qualified service personnel.
3 |
ACEC
