29A-SX1
29A-SX5
29A-SX8
SX-68JF200
2PROM is initialized.
2C BUS CONTROL adjustment
and the MAIN POWER switch must
with the CH UP key of R/C. (or button of1
2
5
2C BUS-CONTROL and the existing analog adjustment. Moreo-
C BUS-CONTROL is composed of the items which are set with the initial values
2
ADJUSTMENT PRECAUTION2PROM (discriminated with the head 4 bytes).
2PROM memory is submitted with the attached sheets for reference, use it.
When the TP1001/1002 are short-circuited, enter into the service mode (Imode).The modes can be sequentially selected with the CH DOWN key of R/C. (or button of set behind door.)The modes can be sequentially selected in the reversed order of set behind door.)The data can be converted with the VOLUME UP/DOWN key of R/C. (or button of set behind door.)When the short circuit between the TP1001/1002 is cut off, it will be released from the service mode.When the MAIN POWER switch set at the service mode side is turned on, the initial value will be automatically set only on the new EThe initial data is set as shown in the attached sheets.Take care that there are the items which need be changed and the items in which the initial values continue set.Instruct that it must set at the service mode side as shown in Item 2-be turned on when the lamp is first turned on after the chassis is assembled. Take care that the beam current may excessively flow if the lamp is turned on unless E
12345123
The model is a mixture of the adjustment items of Iver, since the adjustment with I(preset values) alone and the data variable items, refer to the following.1)Setting method to the microcomputer service mode2)Initial value (preset value) setting3)Since the E
5 |
ACEC
