32N-S400, 36N-S400
CN32S40, CN36S40
Sub-Brightness Adjustment3.58MHz Trap Adjustment
1. Receive a good local channel.1. Receive a good local channel.
2. Make sure the customer brightness control is set to2. Enter the service mode and select the service
center position.adjustment "S16".
3. Enter the service mode and select the service3. This is a two position adjustment, "00" is ON, "01" is
adjustment "S04".OFF.
4. Adjust "S04" data value to obtain normal brightness4. Adjust data value to "01" for normal viewing.
level.
Sharpness and Audio Balance Adjustments
Vertical-Size and Linearity Adjustments
1. Receive a good local channel.
1. Receive a good local channel.2. Enter the service mode and select the service
2. Enter the service mode and select the serviceadjustments "S05" for sharpness and "S17" for audio
adjustment "S09".balance.
3. While observing the top and bottom of the screen,? Sharpness Adjustment
adjust "S09" data value to proper vertical size.3. Adjust data value to "24"(center of data range) for
4. Using the R502 control adjust for the best linearitysharpness adjustment..
? Audio Balance Adjustment
Vertical Phase Adjustment4. Adjust data value to "20"(center of data range) for
Audio balance adjustment.
1. Enter the service mode and select the service
adjustment "S06".Vertical Center Adjustment
2. Adjust data value to "00".
Note:This must be set "00" when changed data1. Receive a good CATV channel.
2. Adjust the S502 so that the picture is centered.
retrace line will appear.
Side Pincushion Adjustment
Horizontal Position Adjustment
1. Receive a good CATV channel or crosshatch pattern
1. Receive a good local channel.
2. Enter the service mode and select the servicesignal.
2. Adjust the R676 so that the outermost line on the
adjustment "S07".
3. Adjust "S07" data value so that picture is centered.screen is straight.
Horizontal Size Adjustment
Caption Position Adjustment (Horizontal)
1. Receive a good CATV channel or crosshatch pattern
1. Receive a good local channel.
2. Enter the service mode and select the servicesignal.
2. Adjust the R678 so that the best horizontal size.
adjustment "S18".
3. A black text box appears on the screen. (see Figure
Energy Save Offset Adjustment
B. below)
4. Adjust "S18" data value so that text box is positioned1. Enter the service mode and select the service
in the center of the screen.adjustment "S20".
2. Adjust data value to "23".
Note : This position is used to preset the level for the
energy save function.
Other Adjustments
1. Enter the service mode.
2. Adjust the following data values as listed below.
SERVICEADJUSTDATA
POSITIONITEM(Hex)
S05SHARPNESS24
S06V-PHASE00
S16TRAP01
S20E-SAVE23
S21TIMER7A
S23TUNER SETUP00
OP1OPTION1BF
Figure B.
OP2OPTION2A7
11 |
ACEC
