32R-S50, 32R-S400
36R-S50, 36R-S400
DESCRIPTION OF SCHEMATIC DIAGRAM
NOTES:WAVEFORM MEASUREMENT CONDITIONS:
1. The unit of resistance "ohm" is omitted.1. Photographs taken on a standard gated color bar
(K=k& =1000& , M=M& )signal, the tint setting adjusted for proper color. The
2. All resistors are 1/8 watt, unless otherwise noted.wave shapes at the red, green and blue cathodes of
3. All capacitors are ? F, unless otherwise noted.the picture tube depend on the tint, color level and
(P=pF=??F)picture control.
4. (G) indicates ?2% tolerance may be used.2. indicates waveform check points (See chart,
5. indicates line isolated ground.waveforms are measured from point indicated to
chassis ground.)
VOLTAGE MEASUREMENT CONDITIONS:
1. All DC voltages are measured with DVM connecteda AND SHADED ( ) COMPONENTS
between points indicated and chassis ground, line= SAFETY RELATED PARTS.
voltage set at 120V AC and all controls set fçor norMARK= X-RAmalY RELATED PARTS.
picture unless otherwise indicated.
2. All voltages measured with 1000? V B & W or ColorThis circuit diagram is a standard one, printed circuits
signal.may be subject to change for product improvement
without prior notice.
WAVEFORMS
16 |
ACEC
