32R-S50/S400,
36R-S50/S400,CR32S40
Vertical-Size and Linearity AdjustmentsSharpness and Audio Balance Adjustments
1. Receive a good local channel.1. Receive a good local channel.
2. Enter the service mode and select the ser2. Enter the servicevice mode and select the service
adjustment "S09".adjustments "S05" for sharpness and "S17" for audio
3. While observing the top and bottom of the screen,balance.
adjust "S09" data value to proper vertical siz? Sharpness Adjustmente.
4. Using the R502 control adjust for the best linear3. Adjust data vity.alue to "24"(center of data range) for
sharpness adjustment.
Vertical Phase Adjustment? Audio Balance Adjustment
4. Adjust data value to "20"(center of data range) for
1. Enter the service mode and select the serviceAudio balance adjustment.
adjustment "S06".
2. Adjust data value to "00".Vertical Center Adjustment
Note:This must be set "00" when changed data
retrace line will appear.1. Receive a good CATV channel.
2. Adjust the S502 so that the picture is centered.
Horizontal Position Adjustment
Side Pincushion Adjustment
1. Receive a good local channel.
2. Enter the service mode and select the ser1. Receivvicee a good CATV channel or crosshatch pattern
adjustment "S07".signal.
3. Adjust "S07" data value so that picture is centered.2. Adjust the R676 so that the outermost line on the
screen is straight.
Caption Position Adjustment (Horizontal)Horizontal Size Adjustment
1. Receive a good local channel.
2. Enter the service mode and select the service1. Receive a good CATV channel or crosshatch pattern
adjustment "S18".signal.
2. Adjust the R678 so that the best horizontal size.
3. A black text box appears on the screen.Figure (see
B. below)
Energy Save Offset Adjustment
4. Adjust "S18" data value so that text box is positioned
in the center of the screen.1. Enter the service mode and select the service
adjustment "S20".
3.58MHz Trap Adjustment2. Adjust data value to "23".
Note :This position is used to preset the le vel for the
1. Receive a good local channel.
2. Enter the service mode and select the service energy save function.
adjustment "S16".
3. This is a two position adjustment, "00" is ON, "01" isOther Adjustments
OFF.1. Enter the service mode.
4. Adjust data value to "01" for normal viewing.2. Adjust the following data values as listed below.
SERVICEADJUSTDATA
POSITIONITEM(Hex)
S05SHARPNESS24
S06V-PHASE00
S16TRAP01
S20E-SAVE23
S21TIMER7A
S23TUNER SETUP00
S22FAO25
S28COL. TEMP. LOW-GE1
S29COL. TEMP. LOW-BAE
S30COL. TEMP. ML-GFA
S31COL. TEMP. ML-BE7
S32COL. TEMP. ML-B08
S33COL. TEMP. HIGH-G14
SERVICE32R-S50,32R-S400, 36R-S400,
POSITION36R-S50CR32S40
OP1B1B7
OP2C7E7
Figure B.
12 |
ACEC
