43C-RD9A
50C-RD9A/9H
2.13.1 Raster position adjustmentthe "SERVICE ONLY" switch again to finish the adjustment.
Or the adjustment can finish by pressing the "STATIC
Adjustment preparationMODE" button in the control access area.
1. Position adjustment This will move an entire color6. The digital con. Usevergence has 2 modes 60Hz (NTSC) and
this adjustment to match colors at the center of the screen.50HZ (PAL), change another mode then adjust again
2. Use the buttons below to switch color to adjust.(2.13.1 ~2.13.3)
["] Green
[ 0 ] RedNOTES:
[']Blue1. CH I/II button ... cross-hatch/video mode.
* Press CH I/II button 5 times to display external signal.
Adjustment Procedure* Press CH I/II Button 5 times again to return to DCU
1. Press the LST - CH button . Extra horizontal lines appearinternal cross-hatch.
to confirm raster position mode.2. MENU button ... remove color mode. Press the MENU
2. Use the cursor buttons to adjust position.button to switch between all colors displayed or adjustment
3. Press the LST - CH button again to exit raster positioncolor and green only.
mode. * Press [ 0 ], then press MENU ... Red and Green
displayed (Blue removed)
NOTES: * Press ['], then press MENU ... Blue and Green
1. Other functions cannot be accessed when in raster positiondisplayed (Red removed)
mode. Press the LST- CH button and confirm extr* aPress ["], then press MENU ... only Green displayed.
horizontal lines disappear to exit raster position mode.
2. Press the MENU button to switch between all colors3. LST-CH button ... raster position adjustment.
displayed or adjustment color and Green only.
[ 0 ] Red
[']Blue2.13.3 Digital Convergence Remote Control
["] Green
2.13.2 Convergence point adjustment
Adjustment preparation
1. Select color to adjust.
[ 0 ] Red
[']Blue
["] Green
2. Use 4, 6, 2 and 5 buttons to move the cursor position
(dotted lines).
3. Use cursor buttons to move the convergence.
4. Adjustment points are 117 points� V.: (H: 9 points). 13
Refer to section 2.13.
5. Start adjustment at the center of the screen.
6. Continue adjustment at next closest position.
7. Adjust center area first, and ending with edge section.
Adjustment Procedure
1. Start adjustment at the center of the screen.
2. Continue adjustment at next closest position.
3. Adjust center area first, and ending with edge sections.
4. Calculation. When convergence adjustment is finished,
press the CH button on the remote control, then the
calculation mode starts. The operation time is about for 5
seconds and no picture appears during this operation. This
operation fills convergence data between each adjustment
points. If you find misconvergence more than 1mm, adjust
the convergence again.
5. Write data to ROM. Press the INDEX button on remote
control. First, press: "ROM WRITE?" is displayed for alarm.
Second, press: Data starts to write to ROM, it takes about
for 10 seconds and no picture appears during this
operation. When Green dot pattern appears, writing
operation is OK. If writing operation is OK, press any
button, to return to the adjustment mode. When red dot
appears, writing operation is NG. If writing operation is
NG, replace digital convergence unit and readjust. Push
37 |
ACEC
