70GF-66SC
ELECTRICAL SPECIFICATIONS
"Power Input ..................... 220V-240 Volts AC 50Hz"Picture Intermediate frequency
B/G..............................................38.9MHz
"Power ConsumptionD/K..............................................38.9MHz
Normal Operating ...................................114W
(Method IEC60107)"Sound Carrier Trap
Stand-by Operating .................................1.3WB/G..............................................33.4MHz
D/K..............................................32.4MHz
"Audio Power Output Rating (MPO) / Impedance
Internal Left Speaker ....................... 10W,"Adjacent Sound Carrier Trap
7WB/G..............................................40.4MHz
D/K..............................................40.4MHzInternal Right Speaker ..................... 10W,
"Adjacent Picture Carrier Trap7W
B/G..............................................31.9MHz"Speakers
D/K..............................................30.9MHz
Left / Right ..................................... 6x 12 cm
"Aerial Input Impedance"Convergence
VHF/UHF ................. 75 ohm UnbalancedStatic (Centre)
"Tuning Ranges.......48.25MHz thru 855.25 MHzbetween any two colours......................0.03cm
Dynamic after static equals zero
VHF: E 2-E12 CH/ OIRT R1- R12Within 10cm (4?) circle...........................0.1cm
S1~S41 CH (HYPERBAND)
UHF: E21~E69 CH, I21~I69 CH10 - 25 cm (4-10?) circle.......................0.14cm
Everywhere else...................................0.18cm
CATV Special Channels
"Focus ....................... High Bi-Potential Electrostatic
"White Level
Set brightness control to get total picture tube cathode current of 600 ?amperes under no signal
condition. Maximum necessary correction of each picture tube cathode current to get 7250 degrees
K-11 MPCD screen temperature should not exceed 15% of its original value.
X=0.304 ? 0.015 Y=0.306 ? 0.015
Specifications are subject to change without prior notice.
WARNING
Part of this chassis is not isolated from the mains supply. When carrying out any servicing work,
ensure that an isolation transformer is connected in the mains supply.
To prevent electric shock, do not remove the cover unless you are qualified to do so. Refer servicing
work to a qualified engineer.
3 |
ACEC
