AH/AU-X108E
AY/AE-X108E
AH/AU-X138E
AY/AE-X138E
1-5 ON-timer
Zone Compressor intermittent timeFanThe ON-timer is set by pressing the ON-timer button.
In order to attain the set temperature at the set time,
J3 min. on - 3 min. offSame as Compressor
the operation starting time is corrected by neuro and
After "3 min. on - 3 min.off"
fuzzy computing one hour before the set time.
is repeated 4 times, the
compressor goes off, and
1-6 OFF-timer
only the fan continues to
K3 min. on - 8 min. off
repeat O3 min. on - 8 The OFF-timer is set by pressing the OFF-timer
min.off�.button. Operation is as follows:
Set temperature
CoolingBy fuzzy computing
HeatingSet the shift up time
1-4 Automatic operation
Cooling setting + 1!C
The operating mode and temperature setting are
FinalHeating setting - 3!C
determined by the room temperature and the external
air temperature.DrySame as above
The operating mode will changeover automatically(Final setting + 1!C)
with the following conditions.
*During Heating
External air
01618(24uC) 2834temperature (!C)Timer set time
Cold
FAN ONLYCooling
(25uC)(26uC)
(25uC)(25uC)
29 (24uC) (23uC) (22uC)CoolingCooling
(Dry)
Heating(Room temperature
- 2!C)Room
213!C
temperature
Room
1
The external air temperature is determined by
temperature
hour
detecting the temperature of the outdoor heat
(uC)
exchanger.
Timer operation startsStops
1. From cooling to heating
Cooling mode will changeover to heating mode when*During Cooling / Dry
condition of indoor temperature 1.8uC lower than the
set temperature conditions for 5 minutes.Timer set time
2. From heating to cooling
Heating mode will change over to cooling mode when
Room
condition of indoor temperature 4.8uC higher than the
temperature
set temperature conditions for 25 minutes under Hot
1!C
keep condition.
1
hour
Set temp.
Set temp.
[uC]
(26uC)(26uC)
22.4Set temp.
Set temp.
Timer operation startsStops
(25uC)(25uC)
22.3Set temp.
1-7 Swing louvre
(24uC)
22.2The louvre is moved by a stepping motor to perform
(Indoor temp.)
swing and fixing in the set position.
If the "FLOW DIRECTION" button is prossed during
swing, it will stop. If the "FLOW DIRECTION" button is
prossed while it is stopped, it will swing.
10182834 [uC]
(Outdoor temp.)1-8 Restart control
Once the compressor stops, this control prevents it
When the set temperature is adjusted within the rangefrom starting again for 3 minutes. It also prevents
of ?2uC by the remote control's key. ( ), thestarting for 80 seconds immediately following plugging
changeover judgement room temp. will also be shiftedinto the power outlet.
within the range of ?2uC.
1-9 One-hour operation
If this button is pressed when operation is
Set temp.
[uC](24uC)stopped, operation will begin and then stop after 1
28.8Set temp.
hour. If pressed when it is operating, will stop after
(23uC)
one hour.
27.8Set temp.
(22uC)
26.81-10Full power operation
(Indoor temp.)
Immediately begins cooling or heating at
maximum power and air flow. Full power stops
after 1 hour.
(During heating) Operates at setting of 32°C.
(During cooling) Operates at setting of 18°C.
010 (Outdoor temp.)[uC]
27 |
ACEC
