each of them to the print head of the corresponding number.
Match the ink tank number
to the print head number.
Make sure that each tab
securely locks the ink tank
by pressing here.
7. Remove the print heads from their protective cases.
Do not touch this area.
The unit may not copy
if it is dirty.
Do not touch the metal portion
of the print head. Doing so may Properly align the tab
make the head inoperable.when inserting the ink
tank.
Note:? Ensure the number on each print head corresponds to the
number on each ink tank.
12. Close the maintenance cover.
8. Insert the print heads.
Insert the black print head into the left carriage opening, and the
colour print head into the right carriage opening.
Black print headColour print head
13. Close the front cover.
Press both edges of the front cover with both of your hands until
it locks.
9. Lower the print head latch.
Lower the latch until it clicks into the latched position.
14. The unit will automatically start a sequence to clean the print
heads and the following message will appear.
Cleaning the Print
Head...
15. After the cleaning sequence is complete, the machine will auto-
matically print the alignment patterns while the following mes-
10. Unpack the ink tanks from their protective wrapping and slsage appears.owly
remove the tape.
Printing...
Alignment Patterns
16. Align the print heads following the procedure "ALIGNING THE
PRINT HEAD". Since the patterns have been already printed,
start with step 5.
Note:? To ensure that the ink heads do not become dry, always
Note:? Hold the ink tank upright when removing the tape. Do notleave the ink tanks installed. If not, poor output will result.
touch the uncovered opening on the ink tank, as ink will
get on your hands.?During ink tank replacement, if the cover is left open for
more than 8 minutes, the carriage will automatically return
?Ensure that there are no pieces of tape remaining on theto its home position.
ink tank.
11. Turn the ink tanks upside down, and then immediately insert |
ACEC
