(1) Cassette paper feed operation5) At this time, the paper is fed passed the paper entry detection
switch (PPD1), and detected by it. After about 0.15 sec from
1) The figure below shows the positions of the pick-up roller, the
paper feed clutch sleeve, and the paper feed latch in the initialdetection of paper by PPD1, the tray paper feed solenoid (PFS)
turns on so that the clutch sleeve projection comes into contact
state without pressing the COPY button after lighting the ready
lamp.with the paper feed latch to stop the pick-up roller. Then the pick-
The paper feed latch is in contact with the projection of the clutchup roller rotates for about 0.15 sec so that the lead edge of the
paper is evenly pressed on the resist roller, preventing against
sleeve.
skew feeding.
2) When the COPY button is pressed, the main drive motor starts
rotating to drive each drive gear.PFS
The pick-up drive gear also is driven at that time. Since, however,
RRS
the paper feed latch is in contact with the projection of the clutch
sleeve, rotation of the drive gear is not transmitted to the pick-upON
roller, which does not rotate therefore.OFF
PFS
RRS
6) To release the resist roller, the tray paper feed solenoid and theOFF
resist solenoid are turned on by the paper start signal to disengage
the resist start latch from the clutch sleeve, transmitting rotation ofOFF
the resist drive gear to the resist roller shaft. Thus the paper is
transported by the resist roller.
7) After the resist roller starts rotating, the paper is passed through
the pre-transfer guide to the transfer section. Images are
3) After about 0.1 sec from when the main motor start rotating, thetransferred on the paper, which is separated from the OPC drum
tray paper feed solenoid (PFS) turns on for a moment.by the drum curve and the separation section.
This disengages the paper feed latch from the projection of the
clutch sleeve, transmitting rotation of the pick-up drive gear to the
paper feed roller shaft, rotating the pick-up roller to feed the paper.
PFS
RRS
OFF
PFSON
RRS
OFF
OFF
8) The paper separated from the drum is passed through the fusing
paper guide, the heat roller (fusing section), POD (paper out
detector) to the copy tray.
4) After more than half rotation of the pick-up roller, the paper feed
latch is brought in contact with a notch on the clutch sleeve,
stopping rotation of the pick-up roller.
AR-122E/152E/153E/157E OPERATIONAL DESCRIPTIONS 7 - 5 |
ACEC
