2. Maintenance display system
Life8K
a. Press and hold the density adjustment LIGHT key for more than 5 sec, and the machine will enter the user
program mode.
Remaining quantity b. Press and hold the "%" key for more than 5 sec, and the remaining quantity will be displayed on the copy
check *1quantity display in one of the following levels: (Remaining quantity display levels: 100%, 75%, 50%, 25%,
Toner
10%, LO)
c. Press the density adjustment LIGHT key to cancel.
Remaining quantity NEAR EMPTYAbout 10%EMPTY
LEDONFlash
MachineOperation allowedStop
Life25K
LEDON at 25K of the developer count.
Selection is available between Not Stop and Stop by Service Simulation (SIM 26-37) Setup.
Developer
(If Stop is selected, the LED will flash and stop at 25K.)
Machine
* Default: Not Stop
* Clear: SIM 24-06
Selection is available among 25K, 13K, 9K, 6K, 3K, and free (no lighting) with SIM 21-1.
LED* Default: 25K
Maintenance
* Clear: SIM 20-1
MachineNot stop.
*1: Installation of a new toner cartridge allows to display the remaining quantity.
The remaining toner indication is based on the number of revolutions of the toner motor.
3. Remaining toner indication
TONER FULL
Display for users
Remaining toner indication
100%
75%Lo
50%
25%LOW LEVEL
100-90%89-75%74-50%49-25%24-10% 10%10 sheets
Indicator
NEAR ENDEND
? The remaining toner indication is based on the number of revolutions of the toner motor.
The toner END indication appears when the END is detected by the toner sensor, or when the number of revolutions of the toner motor reaches a
given number (equivalent to 8K), whichever comes first.
AR-122E N/AR-123E/AR-153E N/AR-157E N GENERAL 1 - 3 |
ACEC
