AR-F152
12) Rotate the MG roller gear to distribute developer evenly.4) Insert Toner unit carefully into the copier.
5) Insert until the hook is engaged with the copier as shown in
the figure below.
Note: Never rotate the gear in the reverse direction.
Note: When carrying Developer unit, do not tilt it extremely
as shown with the arrow in the figure below.
(Prevention of splash of developer)
6) Pull out the shutter in the arrow direction.
13) Insert Developer unit carefully into the copier.
Note: Quick insertion may result in splash of developer. BeNote: Do not hold and carry the shutter. Otherwise the shut-
sure to insert carefully.ter may drop and Toner unit may drop.
14) Confirm that Developer unit is completely inserted to the7) Completion of Toner unit installation
bottom of the machine, fix Developer unit and the machine
with a screw.Close the front and side cabinets.
15) Completion of Developer unit installation
8. LOADING COPY PAPER
7. TONER CARTRIDGE INSTALLATIONNote: This copier is equipped with two paper trays. Load copy
paper into the two paper trays.
1) To prevent against uneven distribution of toner, hold Toner
unit with both hands and shake it several times horizontally.1) Raise the handle of the paper tray and pull the paper tray
out until it stops.
2) Hold the section of Toner unit shown in the figure below,
remove the packing tape, and remove the cushion.
3) Pull out the cushion in the arrow direction.
2) Remove the pressure plate lock. Rotate the pressure plate
lock in the direction of the arrow to remove it while pressing
down the pressure plate of the paper tray.
5 � 3 |
ACEC
