AR-205 [6] ADJUSTMENT 05/24/1999
AR-205
2) Loosen the copy lamp unit wire fixing screw.5) Without moving the scanner drive pulley shaft, manually turn the
scanner drive pulley until the positioning plate is brought into con-
tact with No. 2/3 mirror base unit, then fix the scanner drive pulley.
6) Put No. 2/3 mirror base unit on the positioning plate again, push
3) Manually turn the mirror base drive pulley and bring No. 2/3 mirrorthe projections on the front frame side and the rear frame side of
base unit into contact with the positioning plate.the copy lamp unit to the corner frame, and tighten the wire fixing
At that time, if the front frame side and the rear frame side of No.screw.
2/3 mirror base unit are brought into contact with the positioning
plate at the same time, the mirror base unit parallelism is proper.
If one of them is in contact with the positioning plate, perform the
adjustment of 4).
4) Loosen the set screw of the scanner drive pulley which is not in
contact with No. 2/3 mirror base unit positioning plate.
6 � 5 |
ACEC
