The table below shows the changed points in simulations. (Items marked with* are changed.)
Main Sub Initial Set
ContentsDetails of operation
codecodevaluerange
211Maintenance cycle Used to display the currently set maintenance cycle at the numbers show2* n at right.0~7* When
settingthe set value is entered and the start key is pressed, the set value is stored.
Key operation/Display
0: 2500 sheets4: 150000 sheets (Toner save mode off)
1: 5000 sheets5: FREE (999999 sheets)
2: 25000 sheets *(Toner save mode6: 1000 on)0 sheets
15000 sheets (Toner save mode o7: 7500ff) sheets
3: 50000 sheets *(Toner save mode on)
30000 sheets (Toner save mode off)
266Destination setting Used to display the current destination setting with the numbers at right.70~13
After entering the set value, press the start key, and the set value is stored.
Key operation/Display
0: Japan8: EX AB series
1: USA (Inch series)9: EX inch series (FC conformity)
2: Canada (Inch series)10: EX AB series (FC conformity)
3: Germany 1 (AB series)(Australia, Newzealand)
4: UK (AB series)11: China (AB series)
5: Not used12: Taiwan (AB series)
6: France (AB series)13: Germany 2 (AB series)
7: EX inch series
2610 Model name input*Used to display and register the model name.10~1
Key operation/Display
0 : ARS1401 : AR5015
2 : AR5015N3 : AR5020
2618 Toner save mode settUsed tingo turn on/off the toner save mode.10~1
When this setup is changed, the following setup is also changed automatically.
? SIM21-1-2,3
? SIM21-2-4
Key operation/Display
0 : Toner save OFF
1 : Toner save ON
2642 Transfer timing After completion of warm up, shading is performed and the currently set t3*1,r3,5,ansfer timing
adjustmentadjustment value is displayed.7,9
Key operation
Transfer timing adjustment value: Copy quantity keys
?1? : 240 ms
?3? : 260 ms
?5? : 280 ms
?7? : 300 ms
?9? : 320 ms
301Machine sensor Used to check the sensor in the machine transport system with LED on the op40er~ati4* on panel.
operation check
Display
<Lighting at sensor ON>
Paper entry sensor : Machine position JAM LED
Duplex sensor : Manual feed tray position LEDPaper exit sensor : JAM LED
AR-5015N/5020 SIMULATIONS
- 5 - |
ACEC
