2) Touch the [PAPER TRAY SETTINGS] key.
[6] ADJUSTMENTS
The paper tray selection screen will appear.
1. CHANGING THE PAPER SIZE
PAPER TRAY
RINT
[Upper tray(Tray2)]SETTINGS
A3 to A5R(11x7 to 5-1/2x8-1/2R) size plain paper can be set.
Special paper can be set.TAPRINTER
Two maximum height lines are indicated: one for plain paper and oneORWARDCONDITION
for special paper.
[Middle/Lower tray(Tray3/4)]
3) Touch the [TRAY SETTINGS] key.
A4, B5 or 8-1/2" x 11" size plain paper can be set.
CUSTOM SETTINGS
Use the following procedure to change the size as needed.
PAPER TRAY SETTINGS
1) Pull out paper tray.
If paper remains in the tray, remove it.
TRAY SETTINGS
2) Adjust the guide plates A and B in the tray to the length and width of
the paper.
4) Display the setting screen of the desired paper tray.
CUSTOM SETTINGS
PAPER TRAY SETTINGSOK
FIXED PAPER SIDE 1/4TYPE / SIZE
TRAY 1PLAIN / A4
DISABLE DUPLEX
The guide plates A and B are slidable. Adjust them to the paper size
DOC.
PRINTCOPYFAXI-FAXDISABLE STAPLE
to be loaded while squeezing their lock levers.FILING
DISABLE PUNCH
3) Load paper into the tray.
Do not exceed red line when loading special paper to upper tray.
Touch thekey orkey to display the setting screen of the
4) Gently push tray into the machine.
desired paper tray.
Push the tray firmly all the way into the machine.
Note: To automatically switch to a tray with the same size and type of
5) Set the paper size.
paper (if there is one) in t thathe eventthe paper tray runs out of
Be sure to set the paper size and paper type referring to "2.Setting
paper, display the last screen with thekey and select [AUTO
the paper type and paper size".
TRAY SWITCHING].
If this is not done, paper misfeeds will occur.
5) Touch the [TYPE/SIZE] key.
2. SETTING THE PAPER TYPE AND
PAPER SIZE
PER TRAY SETTINGS
Follow these steps to change the paper type setting if the paper type isTYPE / SIZE
changed in either paper tray. For the paper types that can be used inTRAY 2PLAIN / A4
each tray.
DOC.
PRINTCOPYFAXI-FAX
1) Press the [CUSTOM SETTINGS] key.FILING
The custom setting menu screen will appear.
6) Select the type of paper that was loaded in the tray.
Example: The paper type of tray 2 is selected
CUSTOM SETTINGS
TRAY 2 TYPE/SIZE SETTINGCANCEL
SELECT THE PAPER TYPE.
1/2
PLAINLETTER HEADHEAVY PAPERENVELOPE
PRE-PRINTEDPRE-PUNCHEDLABELS
RECYCLEDCOLOURTRANSPARENCY
1/2
Touch the desired paper type to select it.
The paper size setting screen will appear.
Note: Heavy paper, label sheets and transparency film cannot be used
in trays 1, 3, and 4. Envelopes can only be placed in tray 2.
AR-D28/D27/MU2 ADJUSTMENTS
6 - 1 |
ACEC
