AR-SP3
16) Insert the power plug into the outlet and turn the main switch of3) Remove the OP gear cover and rubber feet from the bottom of the
the copier to the ?ON? position.copier.
Remove the screw and remove the OP gear cover.
17) Perform SIM setting.
Then, take off and remove the rubber feet.
Execute simulation [2] of [26] and enter [1].
18) Check the ON/OFF operation of the open detection sensor and
book detection sensor.
Execute simulation [2] of [2] and check that the indicator on the
operation panel lights up and goes out by opening and closing
the FAX-SPF. When the book detection sensor is turned
ON/OFF, the drum replacement lamp is turned ON/OFF accord-
ingly.
19) Check the copy ratio, and then check the center displacement and
leading edge image void.
Place an original on the document glass and make a copy. Then,
place an original in the document feeder tray and make a copy.
If the center of the copy from the document glass is displaced
from the copy from the document feeder, adjust the center refer-
ring to the service manual.
3. AR-DE9 Installation Manual
4) Install the second cassette unit to the copier.
If the second cassette unit is aligned to the copier, it can be posi-
tioned automatically.
Hold the copier lightly to prevent it from toppling down and
secure the second cassette unit with four screws (M4 � 16).
Turn the main switch to the ?OFF? position and remove the power plug
from the outlet.
1) Remove the DV cartridge from the copier.
Open the bypass tray, side cover, and front cover, and then
remove the DV cartridge.
1
5) Remove the rear cover and connect the connector.
3
Remove the screw and remove the rear cover.
2
Then, connect the connector of the second cassette unit to that
of the copier.
2) Make the copier upright.
Close the front cover, side cover, and bypass tray, and then
make the copier upright in the orientation shown in the illustra-
tion.
2 - 6 |
ACEC
