4. Remove the ADU unit harness cover and connect the
connector. Rear side
Remove the fixing screw of the ADU unit, and remove the harness
cover.
0~0.5mm
Remove the connector of the connector storing section, and connect
it to the ADU unit connector.
Attach the pawl section of the removed harness cover to the ADU unit
and fix with a fixing screw.
At that time, treat the wires so that the connector is stored inside the
harness cover. Be careful not to pinch the wire with the harness
cover.
Insert the paper exit unit into the copier.
Harness coverWhen the alignment guide is not shifted:
remove the paper from the ADU unit, press the CA key and cancelFixing screw
the set mode.
When the alignment guide is shifted:Connector
storing section
1 Insert the paper exit unit.
2 Change the set value.
[EXECUTE]By this operation, the set value is
changed and alignment is
performed again.
Set value
<Example>
ASetting to 45
Connect the power plug of the copier to the power outlet, turn on the
power switch, and follow the following procedures. 45[EXECUTE]
5. Change the system configuration setting. When the set value is changed by 1, the alignment guide width is
1 Perform the mode setting with the key operation of the copier.
changed by 0.5 ~ 0.6mm.
HReference for changing the set value
P C2601
40(Shipment set value)60
The guide is extendedThe guide is narrowed
The current set value is displayed with the above key operation.
2 Change the set value to 2. (The value of 61 or greater or 39 or smaller is invalid.)
3 Pull out the paper exit unit again.
C2OKWith the above operation, the set value can
be changed.4 Check that the clearance between the alignment guide and paper
is 0 ~ 0.5mm.
The set value can be changed with the key operation.
At that time, be sure to shift the paper to the rear side of the
6. Check and adjust the alignment guide. alignment guide for checking.
1 Set the adjustment mode of the alignment guide with the keyRepeat procedures 1 through 4 repeatedly.
operation of the copier.
After adjustment, remove the paper from the ADU unit, press the
CA key and cancel the set mode.
P C5201
7. Print off-center adjustment
With the above key operation, the set value is displayed. A sheet of1 Make a copy. If the center is shifted, set the adjustment mode of
paper is fed from the paper feed section, and transported to the top ofthe print off-center with the key operations of the copier.
the alignment plate of the ADU unit and stopped under the aligned
state. P C5010
2 Pull out the paper exit unit.
3 Check that the clearance between the alignment guide and theWith the above key operation, the current set value is displayed.
paper is 0 ~ 0.5mm. 2 Select the item of ADU from the message mÂe ]nu wkeiy tha [nd
[ ? ] key.
At that time, be sure to shift the paper to the rear side of the
alignment guide for checking.Adjustment value: 1.7mm
� 3 � |
ACEC
