4. Attach the lock plates.
Cut out the three lock plate mounting holes on the copier using aConnector cover
Phillips screwdriver or the like and remove the burrs using a flat-blade
screwdriver or the like.
Then remove the screw from the left cabinet of the copier and secure
the lock plates to the copier as shown in the figure using screws B
(one for each plate) and positioning screws (one for each plate). (Be
careful about the orientation of the lock plates.)
Screw
Mounting holes
Connector
Screw
Lock plate
Screw B
7. Check and adjust the height of the finisher.
Positioning screw
Move the finisher toward the copier, and check and adjust the height
Positioning screw
Lock plate
so that the guide pin of the copier is inserted smoothly into the
Screw B
positioning hole of the finisher.
5. Connect the finisher with the copier.
Cut out the two mounting holes at the lower part of the desk (leftmost
hole and third hole from the left) using a Phillips screwdriver or the
like and remove the burrs using a flat-blade screwdriver or the like.
Secure the mounting plate that is attached to the finisher connecting
plate to the lower part of the desk using two screws C.
ASince adjustment has been made at shipping, this adjustment
Mounting holes
is basically not needed. If the guide pin should not be inserted
smoothly, adjust the height using the following procedure.
<1> Push the finisher into the copier.
Then, rotate the adjusting screw on the rear side of the finisher
lower part (Fig. 1) so that length b of the lock plate and lock
pawl on the rear side is within ?0.5 mm in relation to length a of
the lock plate and lock pawl on the front side.
Mounting plate
Screws C
6. Connect the finisher connector.
Cut the connector cover for connection of the finisher relay harness
connector on the copier using nippers.
Adjusting screw
Then connect the finisher relay harness connector to the connector
on the copier and secure the connector by tightening the screw on
[Fig. 1]
the connector.
ba
Lock plate Lock plate
1 � 3 |
ACEC
