[06]SIMULATIONS :/FAXSOFTWARESWITCH.fm 11 Mo+ 9Ţ9�9�9a9�9�?9�9Ţa?2??a?
?�9Ţ(9Ţ9a 1
Main Sub ContentsRemark
codecode
664Signal send mode
Used to send signals to the line and the machine speaker by setting the signal number. (Signal send is
continued until interruption is instructed by pressing RETURN key.) The signal send level is selected from
0db and the soft SW values. Since the level setting is not required for 01 and 31 - 35, the selection menu
does not appear. The signal send level is returned to the soft SW set value before execution of the mode
when completing the mode.
CA key: Simulation cancel
Sim66-4 SIGNAL OUT
Interrupt key : Sub code input window
SIGNAL SELECTC key: Input clear
key: Page select
10-key: Number input and item selection
(1 - 35)OK key: Input value settlement and execution
START key : Input value settlement
RETURN key : Signal send stop
1sec later
Sim66-4 SIGNAL OUT
Sim66-4 SIGNAL OUT
1:NO SIGNAL34:DP MAKE
35:DP BREAK
2:33600bps(V34)
3:31200bps(V34)
(1 - 35)XX
(1 - 35)XX
After selection with 10-key
OKThe window is switched with the up and down keys.
Input and switching the window are irrelevant.
Sim66-4 SIGNAL OUTNot highlighted with an input of a value.
The window is not switched, either.
33600bps(V34)
1:MAXWhen "1: NO SIGNAL" or "31: PSEUDO RNG" - "33: R.B. TONE NONE"
2:SOFT SW.is selected, "0dB" and "SOFT SW" are not selected.
(1 - 2)XWhen one of these is selected, the second line is the signal name,
the third and fourth lines are empty, and the fifth line is EXEC display.
OK
Sim66-4 SIGNAL OUT
33600bps(V34)
0dB
EXEC
After pressing OK key
OK
Sim66-4 SIGNAL OUT
33600bps(V34)
PRESS BACK TO STOP
EXEC
Return
SIM66-4 initial window
6Print pass code print
Used to print the confidential ID table (confidential box number, confidential box name, confidential pass
code). Sharp mode confidential information is printed separately.
OK
Sim66-6 PASS CODESim66-6 PASS CODE1sec later
PRINT CONF.PRINT STORED
EXECOK
OK
Sim66-6 PASS CODESim66-6 PASS CODE
NO DATACA key: Simulation cancelCAN NOT PRINT1sec later
Interrupt key : Sub code input
window
OK key: Settlement
START key : Settlement
1sec laterC key: Disable
Return key : Disable
AR-FX11 SIMULATIONS, FAX SOFTWARE SWITCH 6-11 |
ACEC
