c. Rear edge shaft change-over2) Then fit the paper feed tray on the lower side of the side plate
1) Remove the rear edge shaft fixing screw (blue) on the rightF and the side plate R with the engraved marks of the side
side of the paper feed tray, and remove the rear edge shaft.plates according to the size, and insert it. Also fit the upper
side to the size and fix it with the four fixing screws (blue).
2) Tighten the removed rear edge shaft with the fixing screw
(blue screw) and store it in the storage space inside the front
cabinet.
FR
b. Auxiliary guide size change-over
3) Push the large capacity tray slowly into the original position. Since the auxiliary guide is unnecessary, fix it to A4 or LT. (For
protection against missing of the part)
c. Rear edge shaft change-over
1) Remove the rear edge shaft fixing screw (blue) on the right
side of the paper feed tray, and remove the rear edge shaft.
(2) Change A4 size to B5 size
a. Side plate size change-over
1) Remove the four fixing screws (blue) which are fixing the2) Change the direction of the removed rear edge shaft as shown
upper and the lower sections of the side plate F and the sidein the figure below, insert it into the installing hole in the lower
plate R.paper feed base. Fit the upper section with a fixing screw (blue
screw).
F sideR side
AR-LC8 UNPACKING AND INSTALLATION 3 - 5 |
ACEC
