[06]SIMULATIONS :/FAXSOFTWARESWITCH.fm 54 Mo+ 9Ţ9�9�9a9�9�?9�9Ţa?2??a?
?�9Ţ(9Ţ9a 1
SWBit ItemSwitch serection and functionU.S.A. CAU.K GRFRInitial valueKey operator
No.No.
134 1 Summer timeUsed to set whether the summer time is automatically set 00111Follow the YES
or not.destination.
1Enable0Disable
2 Receive rejection Used to set whether the rejected record is remained on 00000Recorded
recordthe communication report or not when receive is rejected
by the receive rejection function.
1Not recorded0Recorded
3,4 Time until resetting When send is made via a satellite, if the DIS signal is not 0000010s
when G3 DIS acknowledged, the receive level is adjusted again and 11111
cannot be received receive is tried again. This setting is used to set the time
in V.8 phase.until resetting.
Bit No.34
8s00
10s01
12s10
14s11
5 Report table output Used to set whether the communication report is 00000Not output
when in receive outputted or not when receive is rejected with the receive
rejectionrejection function. ?Output? is enabled only when SW134-
2 is set to ?0?.
1Output0Not output
6 Sheet count Used to set whether an error page is included in the send 00000Send error
method in case of quantity count in FAX send or not. The default is: an error pages are
an errorpage is not counted.not included.
1Send error pages are 0Send error pages are
included.not included.
7 Not used00000
8 YES/NO of quick Used to set whether the quick memory send ON/OFF is 11111Setting is
memory send displayed on the menu or not.displayed.
setting1Setting is displayed. 0Setting is not
displayed.
135 1-4 Scanner resource Used to set the time out of the scanner warm-up time in 0000026sec
securing time out in direct send.00000
direct sendBinary input
20 - 50 sec 11111
11111
5 Energy-saving Used to set whether the machine is reset from the 11111Reset
reset with an energy-saving mode or not when the hand set of the (Complete
external TELexternal telephone is lifted in the energy-saving mode. reset)
The default is: Not reset in Japan only.
1Reset (Complete 0Not reset (Only 24V
reset)is reset.)
6 Not used00000
7 External auditor Used to set whether Enable/Disable of the FAX 00000Check
checkdepartment management when an external auditor is
used. The default is Disable.
1Not check0Check
8 Not used00000
136 1 RTC error Used to correct advancement of the clock. The default is 00000No error
adjustmentNo Correction.adjustment
1Error adjustment0No error adjustment
U.S.A.: U.S.A.CA: CanadaU.K: U.KingdomGR: GermanFR: France
AR-FX11 SIMULATIONS, FAX SOFTWARE SWITCH 6-54 |
ACEC
