3. Connect the USB cable and the network cable.3. Connect the USB cable and network cable.
1) Attach the supplied cable clamp to the position shown 1)in Athe illustra-ttach the supplied cable clamp to the position shown in the illustra-
tion.tion.
2) Connect the USB cable to the network expansion kit and t2) Connehe mainct the USB cable to the network expansion kit and the main
unit.unit.
At this time, reduce slack of the cable with the cableA t tclamhip ass time, reduce slack of the cable with the cable clamp as
shown in the illustration.shown in the illustration.
3) Connect the network cable.3) Connect the network cable.
Insert the power plug of the copier to the outlet, turn the main
switch of the copier to the ?ON? position, and then perform net-
work setting and installation of the software.
B. FOR AR-M160/M205/5220
Turn off the main switch of the main unit and remove the power
plug of the main unit from the outlet.
1. Cut out the cut-out portions from the rear cabinet.
1) Cut out three cut-out porttihe rear cons from abinet using a cutter or
the like.
2) Use a Phillips screwdriver or the like to open a hole.Insert the power plug of the copier to the outlet, turn the main
switch of the copier to the ?ON? position, and then perform net-
work setting and installation of the software.
2. Attach the network expansion kit.
Connect the connector of the netexpawornsion kitk to the connector of
the main unit and put excessive harness into the cut-out portion in the
main unit.
Engage the two pawls on the rear of the network expansion kit with the
cut-out portions of the main unit and network expansion kit using the
supplied screw (3 x 14).
AR-NB2N UNPACKING AND INSTALLATION
3 - 2 |
ACEC
