AR-PX1
(Parts list)
AR-PX1/PX2 Installation ManualNo.Part nameQuantity
SEE SHARP COPIER INSTALLATION MANUAL TO DETERMINE SUITABILITY.ACCESSORY9K111Printer I/F PWB1FOR USE WITH COMPATIBLE SHARP COPIERS.I.T.E.
2Wake up signal harness (connected to the printer I/F PWB)1
3Printer I/F connector unit1
4Flat cable1
[1] OUTLINE5Flat cable clip1
6Screw (M3)4
This kit is used to connect the printer controller with the scanner and7Printer cable1
the printer section in the machine.
2. Parts assembly
1. Kit composition1) Open the front cabinet, and pull out the toner hopper unit.
This kit is composed of the following major parts:
?Printer I/F PWB
?Printer I/F connector unit
?Internal connection cable
?External connection cable
2. Outline of operations
(Printer mode)
Each color image data of 8bit of Y/M/C/K outputted from the print
controller is converted into the engine logic level in the printer I/F
PWB.
(Scanner mode)
Each color image data of 8bit of R/G/B scanned by the scanner is2) Remove the toner hopper connector cover, and remove the toner
hopper connector.
inputted to the printer I/F PWB, and converted into the differential
output and sent to the print controller.
(Circuit system)
High-speed data transmission/reception is performed between the en-
gine and the print controller. For that, the differential I/O system is
employed to increase the noise margin.
[2] SETUP
(Necessary tools)3) Remove the toner hopper unit.
1Screwdriver
2Short screwdriver
3Nippers
1. Unpacking
4) Remove the right upper cabinet.
- 1 - |
ACEC
