27L-S100/27L-S180
CL27S10/CL27S18
DESCRIPTION OF SCHEMATIC DIAGRAM
NOTES:WAVEFORM MEASUREMENT CONDITIONS:
H1. The unit of resistance "ohm" is omitted.1. Photographs taken on a standard gated color bar
(K=kW =1000W , M=MW )signal, the tint setting adjusted for proper color. The
2. All resistors are 1/8 watt, unless otherwise noted.wave shapes at the red, green and blue cathodes of
3. All capacitors are ? F, unless otherwise noted.the picture tube depend on the tint, color level and
(P=pF=??F)picture control.
4. (G) indicates ?2% tolerance may be used.2. indicates waveform check points (See chart,
5. indicates line isolated ground.waveforms are measured from point indicated to
6.G indicates hot ground.chassis ground.)
VOLTAGE MEASUREMENT CONDITIONS:�AND SHADED ( ) COMPONENTS
1. All DC voltages are measured with DVM connected= SAFETY RELATED PARTS.
between points indicated and chassis ground, line'MARK= X-RAY RELATED PARTS.
voltage set at 120V AC and all controls set for normal
picture unless otherwise indicated.DRGANNES MARQUES � ET HACHRES ( ):
2.FAll voltages measured with 1000? V B & W or ColorPIECES RELATIVES A LA SECURITE.
signal.MARQUE ' : PIECS RELATIVE AUX RAYONS X.
This circuit diagram is a standard one, printed circuits
may be subject to change for product improvement
without prior notice.
E
WAVE FORMS
D
C
B
A
12345671890
16 |
ACEC
