32L-S400, 36L-S400
CL32S40, CL36S40
DESCRIPTION OF SCHEMATIC DIAGRAM
NOTES:WAVEFORM MEASUREMENT CONDITIONS:
1. The unit of resistance "ohm" is omitted.1. Photographs taken on a standard gated color bar
(K=kW =1000W , M=MW )signal, the tint setting adjusted for proper color. The
2. All resistors are 1/8 watt, unless otherwise noted.wave shapes at the red, green and blue cathodes of
3. All capacitors are ? F, unless otherwise noted.the picture tube depend on the tint, color level and
(P=pF=??F)picture control.
4. (G) indicates ?2% tolerance may be used.2. indicates waveform check points (See chart,
waveforms are measured from point indicated to
5. indicates line isolated ground.
chassis ground.)
6. indicates hot ground.
� AND SHADED ( ) COMPONENTS
VOLTAGE MEASUREMENT CONDITIONS:= SAFETY RELATED PARTS.
1. All DC voltages are measured with DVM connected
between points indicated and chassis ground, lineŤMARK= X-RAY RELATED PARTS.
voltage set at 120V AC and all controls set for normalDRGANNES MARQUES � ET HACHRES ( ):
picture unless otherwise indicated.
PIECES RELATIVES A LA SECURITE.
2. All voltages measured with 1000? V B & W or ColorMARQUE Ť : PIECS RELATIVE AUX RAYONS X.
signal.
This circuit diagram is a standard one, printed circuits
may be subject to change for product improvement
without prior notice.
WAVEFORMS
15 |
ACEC
