XL-520W/CP-520
OPERATION MANUAL
Press the ON/STAND-BY button to enter the stand-by mode.Unplug the AC power lead from the AC INPUT socket on this unit.Whilst pressing down the MEMORY/SET button and the X- BASS/EQUALIZER button, plug the AC power lead into the AC INPUT socket on this unit.
To erase all of the stored memory contents (clock and timer settings, tuner and CD presets). If the display is not correct. If the operation is not correct.The operation explained above will erase all data stored in memory, such as clock and timer settings, tuner and CD pres- ets.Remote controlReplace the batteries if control distance decreases or operation becomes erratic.Periodically clean the transmitter LED on the remote control and the sensor on the main unit with a soft cloth.Exposing the sensor on the main unit to strong light may in- terfere with operation. Change the lighting or the direction of the unit.Keep the remote control away from moisture, excessive heat, shock, and vibrations.
Reset the microcomputer under the following conditions: ll l1 23Caution: lnNotes concerning use: llll
2,3
15
3
15
0.2 m - 6 m (8" - 20')
RESETTING THE MICROCOMPUTER3
1PREPARATION FOR USE
The 24-hour display will appear. The 12-hour display will appear.
?
?
Press the ON/STAND-BY button to enter the stand-by mode.Press the MEMORY/SET button.Press the PRESET ( or ) button to select the time display mode. "0:00" (0:00 - 23:59) "AM 12:00" (AM 12:00 - PM 11:59)Press the MEMORY/SET button.Press the PRESET ( or ) button to adjust the hour.Press the MEMORY/SET button.Press the PRESET ( or ) button to adjust the minutes.Press the MEMORY/SET button.If this happens, follow the procedure below to change the clock time.Press the ON/STAND-BY button to enter the stand-by mode.Perform steps 4 - 8 above.Perform steps 1 - 3 in the section "RESETTING THE MICRO-
COMPUTER", on page 6.Perform steps 1 - 8 above.
Note that this can only be set when the unit is first installed or it has been reset (see page 6).Press the PRESET button once to advance the time by 1 hour. Hold it down to advance continuously.When the 12-hour display is selected, "AM" will change auto- matically to "PM".Press the PRESET button once to advance the time by 1 minute. Hold it down to change the time in 5 minute intervals.The hour setting will not advance even if minutes advance from "59" to "00".The clock starts operating from "0" seconds. (Seconds are not displayed.)In the event of a power failure or when the AC power lead is disconnected, the clock display will go out. When the AC power supply is restored, the clock display will flash on and off to indicate the time when the power failure occurred or when the AC power lead was disconnected.
123l45ll67ll8lNote: lTo change the clock time:12To change the time display mode:12
PRESET
( / )
PRESET ( / )AM 12:00
MEMORY/ SET0:00
ON/ STAND-BYMEMORY/ SET
In this example, the clock is set for the 24-hour (0:00) system.23456
78
SETTING THE CLOCK ON/ STAND-BY
� 5 � |
ACEC
