DV-HR300S/HR350S
DV-HR300H
DV-HR300X
Y Precautions when replacing the traverse mechanism
1) Do not touch the pickup 1, guide shaft 2, spindle motor 3, thread motor 4, adjusting screw 5 and follower 6.
2) Wear an earth band during the replacement.
3) Keep the traverse mechanism away from dust or dirt.
Pay special attention to objective lens (A) of pickup 1, lead screw (B) of thread motor 4 and rubber surface (C) of
spindle motor 3.
4(C)6
3
5
1(A) 25(B)
Y Notes when inserting the tray
1) Before inserting the tray, set the shifter to the rightmost position with the unit straight in front. If the shifter is not set
properly, malfunction may result or the tray may get stuck inside.
2) The shifter works with the convex part of the (a) section located in the lower part of the unit. (See page 9 of the
service manual.)
Shifter
Shifter
Y Removing the tray
1) Pull out the tray to the end of the stroke.
2) Insert the jigs from left and right sides of the tray at the same time.
3) Remove the tray with the jigs.
Jig (thin board)
13 |
ACEC
