STANDARD NOTES FOR SERVICING
Circuit Board IndicationsHow to Remove / Install Flat Pack-IC
a. The output pin of the 3 pin Regulator ICs is indicated1. Removal
as shown.
With Hot-Air Flat Pack-IC Desoldering Machine:
(1) Prepare the hot-air flat pack-IC desoldering ma-
Top ViewBottom View
chine, then apply hot air to the Flat Pack-IC (about 5
Inputto 6 seconds). (Fig. S-1-1)
OutIn
b. For other ICs, pin 1 and every fifth pin are indicated
as shown.
5
Pin 1
10
Fig. S-1-1
c. The 1st pin of every male connector is indicated as
shown.(2) Remove the flat pack-IC with tweezers while apply-
ing the hot air.
(3) Bottom of the flat pack-IC is fixed with glue to the
CBA; when removing entire flat pack-IC, first apply
Pin 1soldering iron to center of the flat pack-IC and heat
up. Then remove (glue will be melted). (Fig. S-1-6)
(4) Release the flat pack-IC from the CBA using twee-
zers. (Fig. S-1-6)
Instructions for Connectors
Caution:
1. When you connect or disconnect the FFC (Flexible1. Do not supply hot air to the chip parts around the flat
Foil Connector) cable, be sure to first disconnect the
pack-IC for over 6 seconds because damage to the
AC cord.chip parts may occur. Put masking tape around the
2. FFC (Flexible Foil Connector) cable should be in-flat pack-IC to protect other parts from damage.
serted parallel into the connector, not at an angle.(Fig. S-1-2)
2. The flat pack-IC on the CBA is affixed with glue, so
be careful not to break or damage the foil of each pin
or the solder lands under the IC when removing it.
FFC Cable
Hot-air
Flat Pack-IC
Desoldering
Machine
ConnectorCBA
CBA
* Be careful to avoid a short circuit.Masking
Flat Pack-ICTape
Tweezers
Fig. S-1-2
1-4-1DVD_NOTE |
ACEC
