4. PAPER ROLL REPLACEMENT(2) PROTECTION TUBE
Never insert paper roll if torn. Doing so will cause paper to (2)-1.jam. EL-2631L (ABC, ACO), EL-2615P
Insulate between the transformer and the AC cord connector with pro-
Always cut leading edge with scissors first.
tection tubes (2 pcs x 2 positions).
1. Insert the leading edge of the paper roll into the opening. (Fig.1)
Protection tube (2 pcs)
Transformer
Protection
tube (2 pcs)
Fig.1
2. Turn the power on and feed the paper by pressing . (Fig.2)
(2)-2. EL-2631L (TRC)
Fig.2
The EL-2631L (TRC) uses 14 protection tubes in total (that is, 2 pcs x 7
3. Insert the paper roll to the paper holder. (Fig.3)positions) as shown above.
[VOLTAGE SELECTOR]
Protection tube
Protection tube(One: Outside)
(Heat contraction tube)
2 pcs/position
Protection tube
x(One: Inside)
Fig.35 positions
Caution: Do not pull paper backwards as this may cause damage to
printing mechanism.
5. NOTES FOR SERVICING
Use two protection tubes at
every one position.
(1) SL-SW BLINDER (4P/6P)
[FUSE HOLDER]
Protection tube
(2 pcs)
(6P)(4P)
Fuse
It inserts so that it cuts, Key Top side.holder
and it may lack and a
part may come to the
Key Top side.
SLIDE SW UNIT
Protection tube
(2 pcs)
SL-SW MASK (S)
SL-SW MASK (L)
UPPER CASE
EL-2631L/2615P PAPER ROLL REPLACEMENT
- 3 - |
ACEC
