Power supplySynchronization
Battery usedSupplied Items
?Sharp Electronic Organizer EL-6790
TypeModelQuantityApplication
?One 3.5" Floppy Disk(PC Interface Software)
Lithium batteryCR20322Unit operation
?PC Interface Cable
Lithium batteryCR20321Memory backup
?PC Interface Software User?s Guide (this sheet)
Please contact your nearest SHARP dealer if any of the above items are
?Do not remove both the operation and memory backup batteries
missing from the EL-6790P package or are damaged.
at the same time. Doing so will clear the memory of its contents.
?Be sure to write down any important infomation stored inSystem Requirements
memory before replacing the batteries.?Windows ? 98, or Window 95s ?
?IBM-compatible 486 or Pentium processor
(33 MHz or greater)
1. Precautions
?8MB free hard disk space
Since improper use of the batteries may cause leakage or explosion,
strictly observe the following instructions.?16MB RAM available
?Insert the battery with its positive side (+) correctly p?osiVGtioA monenid.tor or better
?
?Never throw batteries into a fire because they might expl?odMicroe.soft Mouse or compatible Pointing Device
?3.5" disk drive
?Keep batteries out of reach of children.
?One available serial port with D-sub 9-pin connector
?When batteries become weak, remove them from the Organizer
immediately to avoid battery leakage and corrosion inside the Or-
Connecting Your EL-6790 to a PC
ganizer.
Because the batteries in the Organizer were installed at the factory, they
may become depleted before the specified expiration time is reached.
2. Operating Batteries Replacement
(1) Battery replacement time EL - 6 7 9 0
Yo u r PC
When " BATT " is displayed, immediately replace the batteries with new
ones. If the battery level is very low, the alarms or the key touch tone may
not sound, or similarly the Backlight may remain on for less than the set
interval or it may not function. Continued use of the Organizer with
P C I n t e r f ac e C abl e
consumed batteries can alter or clear the memory contents.( s uppl i e d)
Memory contents may be lost if the batteries are improperly replaced or if
the following instructions are disregarded.
?Make sure the power is turned off before replacing the batteries.
1. Turn off your PC and the EL-6790.
?Do not press until the battery replacement procedure is com-
pleted.2. Connect the standard 9-pin connector of the PC interface cable into a
COM port on your PC.
(2) Replacing the batteries
1. Press to turn the power off.NOTE
2. Loosen the screw (counter clockwise) and?Using a 25-pin connector instead of the standard 9-pin connector(F i g . 1 )
requires an additional adaptor.
remove the battery holder cover on the back of
unit. (Fig. 1)3. Connect the other end of the PC Interface Cable into the PC interface
connector located on the left side of the EL-6790.
3. Remove the used batteries using a ball-point
(F i g . 2 )
pen or similar object. (Fig. 2)
Do not use a mechanical pencil or sharp
pointed object.
4. Install two new batteries with the positive sides (+) facing up.
5. Replace the holder cover and secure it with the screw.
6. Press to turn the power on. If nothing appears on the display,
press thReE SET switch and press and hold for two or three
seconds.
7. Set the clock to the correct time. |
ACEC
