[key setup procedure]
CHAPTER 3. SRV. RESET AND
MASTER RESET
*2
MRS-20Key position setFree kFreeye key setup
executed*1complete.
1. SRV. reset (Program Loop Reset)0
Disable
Used to return the machine back to its operational state after a lock-up
has occurred.
NOTES:
Procedure
?Method 1*1:When the 0 key is pressed, the key of the key number on display
is disabled.
1) Unplug the AC cord from the wall outlet.
*2:Push the key on the position to be assigned. With this, the key of
2) Set the mode switch to (SRVc ) position.the key number on display is assigned to that key position.
3) Plug in the AC cord to the wall outlet.
Key numberKey nameKey numberKey name
4) Turn to (SRV) position from (SRVc ) position.1Numeric key "0"10Numeric key "9"
?Method 22Numeric key "1"11Numeric key "00"
1) Set the mode switch to PGM2 position.3Numeric key "2"12Numeric key "000"
2) Turn off the AC switch.4Numeric key "3"13Decimal point key
5Numeric key "4"14CL key
3) While holding down JOURNAL FEED key and RECEIPT FEED
key, Turn on the AC switch.6Numeric key "5"15� key
Note: When disassembling and reassembling always power up using7Numeric key "6"16ST key
method 1 only. Method 2 will not reset the CKDC8.8Numeric key "7"17TL key
Note: SRV programming job#926-B must be set to "4" to allow PGM9Numeric key "8"
program loop reset.
2. Master reset (All memory clear)
There are two possible methods to perform a master reset.
?MRS-1
Used to clear all memory contents and return machine back to its
initial settings and return keyboard back to default keyboard layout.
Procedure
1) Unplug the AC cord from the wall outlet.
2) Set the MODE switch to the (SRVc ) position.
3) Plug in the AC cord to the wall outlet.
4) While holding down JOURNAL FEED key, turn to (SRV) position
from (SRVc ) position.
?MRS-2
Used to clear all memory and keyboard contents.
This reset returns all programming back to defaults. The keyboard
must be entered by hand.
This reset is used if an application needs different keyboard layout
other than that supplied by a normal MRS-1.
Procedure
1) Unplug the AC cord from the wall outlet.
2) Set the MODE switch to the (SRVc ) position.
3) Plug in the AC cord to the wall outlet.
4) While holding down JOURNAL FEED key and RECEIPT FEED
key, turn to (SRV) position from (SRVc ) position.
5) Key position assignment:
*After the execution of MRS-2, only the RECEIPT FEED and JOUR-
NAL FEED keys can remain effective on key assignment. Any key
can be assigned on any key position on the main keyboard.
3 - 1 |
ACEC
