CHAPTER 3. SRV. RESET AND MASTER RESET
1. SRV. reset (Program Loop Reset)
Used to return the machine back to its operational state [key setup procedure]after a lock-
up has occurred.
Procedure
*2
?Method 1MRS-20Key position setFree kFreeye key setup
executedcomplete.
1) Unplug the AC cord from the wall outlet.*1
0
2) Set the mode switch to 2) posi(SRVtion.Disable
3) Plug in the AC cord to the wall outlet.
4) Turn to (SRV) position from2) posi (SRVtion.
NOTES:
?Method 2
1: When the 0 key is pressed, the key of the key number on display
1) Set the mode switch to PGM2 position.is disabled.
2) Turn off the AC switch.2: Push the key on the position to be assigned. With this, the key of
the key number on display is assigned to that key position.
3) While holding down JOURNAL FEED key and RECEIPT FEED
key, Turn on the AC switch.
Key numberKey nameKey numberKey name
Note: When disassembling and reassembling always power up us-1Numeric key "0"10Numeric key "9"
ing method 1 only. Method 2 will not reset the CKDC8.
2Numeric key "1"11Numeric key "00"
Note: SRV programming job#926-B must be set to "4" to allow PG3MNumeric key "2"12Numeric key "000"
program loop reset.
4Numeric key "3"13Decimal point key
5Numeric key "4"14CL key
6Numeric key "5"15? key
2. Master reset (All memory clear)
7Numeric key "6"16ST key
There are two possible methods to perform a master reset.8Numeric key "7"17TL key
?MRS-19Numeric key "8"
Used to clear all memory contents and return machine back to its
initial settings and return keyboard back to default keyboard layout.
Procedure
1) Unplug the AC cord from the wall outlet.
2) Set the MODE switch to th2) posie (SRVtion.
3) Plug in the AC cord to the wall outlet.
4) While holding down JOURNAL FEED key, turn to (SRV) position
from (SR2V) position.
?MRS-2
Used to clear all memory and keyboard contents.
This reset returns all programming back to defaults. The keyboard
must be entered by hand.
This reset is used if an application needs different keyboard layout
other than that supplied by a normal MRS-1.
Procedure
1) Unplug the AC cord from the wall outlet.
2) Set the MODE switch to th2) posie (SRVtion.
3) Plug in the AC cord to the wall outlet.
4) While holding down JOURNAL FEED key and RECEIPT FEED
key, turn to (SRV) position 2) posifrom (SRVtion.
5) Key position assignment:
After the execution of MRS-2, only the RECEIPT FEED and
JOURNAL FEED keys can remain effective on key assignment.
Any key can be assigned on any key position on the main key-
board.
3 - 1 |
ACEC
