FO-1450ZA
3. Diagnostic items description 3. 6. Signal send mode
This mode is used to send various signals to the line.
3. 1. Soft switch setting mode
FAX signals are sent in the level set by the soft switch.
Used to change the soft switch settings.
[1] No signal (CML signal turned on)
The soft switch which is stored internally is set by using the keys.
[2] 9600bps
The available soft switches are SW-A1 to SW-L2.
[3] 7200bps
The content of soft switches is shown in page 2-5 to 2-16.
[4] 4800bps
The contents are set to factory default settings.
[5] 2400bps
3. 2. ROM & RAM check mode[6] 300bps (FLAG)
ROM executes the sum check, and RAM executes the matching test.[7] 2100Hz (CED)
The result will be notified with the number of short sounds of the[8] 1100Hz (CNG)
buzzer as well as by printing the ROM & RAM check list.
[9] END
Number of short sounds of buzzer? No error0
The signal can be checked by plugging the handset into the TEL line
1 ? ROM errorconnector on the rear of the machine.
2 ? RAM error (32Kbyte)
3. 7. Memory clear mode
3. 3. Aging mode This mode is used to clear the backup memory and reset to the
If any document is first present, copying will be executed sheet bydefault settings.
sheet. If no document is present, the check pattern will be printed
sheet by sheet. This operation will be executed at a rate of one sheet3. 8. CCD adjust mode
per 5minutes, and will be ended at a total of 10 sheets.
This mode is used to adjust the optical system. Since the copy is
function performed, set the original. To abort the copy operation,
3. 4. Panel check mode press the STOP key. To restart press the START key. When the copy
In this mode, whether each key operates properly or not is checked.is completed or when the STOP key is pressed in the interruption
Press a key on the operation panel, and the corresponding key will bestate, exit from this mode occurs.
displayed. In this mode, press the STOP key, and the list of the keys
pressed in this mode will be printed with the mode ended.3. 9. All black copy mode
Whether all keys are pressed in this mode or not will be judged whenThis mode is used to check the print head.
the list is printed, and the result will be printed.All-dot print is executed unconditionally until 3 is obtained except
when any trouble occurs (recording paper has run out, recording
3. 5. Check pattern modepaper jam, thermal protect).
This mode is used to check the status of print head. Two sheets of
check pattern are printed. The following information of check pattern3. 10. Auto feeder mode
is printed.
In this mode, a document is inserted and discharged to check the
1 Vertical stripes (alternate white and black lines) Approx. 30 mmauto feed function.
2 Full black Approx. 3After this mode is started, set a document, and the document feed0 mm
will be automatically tested.
13. 11. Entry data send
This mode is used to send the registered data to the remote machine
and make the remote machine copy the registered information. When
this mode is used for sending, the remote machine must be set to the
2
entry data receive mode.
The information to be sent is as follows.
1. Telephone book data
2. Transmitter registration data
3. Optional setting content
4. Soft switch content
5. Junk FAX number
6. Timer reservation data
(for models in which timer reservation is possible)
7. Pass code number
(only for models with polling function)
8. Program group information
9. Print set up list
2 � 3 |
ACEC
