FO-2900DE
5 Remove two screws.Optical section
6 Pull DV bias electrode toward you, and remove it from the lowerYDo not touch the mirror fixing screw in the optical section. If touched,
frame.the mirror bracket may be change, causing a shift in the print image
position or vague images. The mirror angle cannot be adjusted in the
market.
YDo not touch the volume attached. If touched, normal images cannot
be produced. This adjustment cannot be made in the market.
Not touch
DV bias electrode
6
Not touch
5
Not touch
Fig. 50
Note for assembly
YWhen attaching DV bias electrode, adjust so that the contact is over
the DC-bias electrode of the PWB unit.
Not touch
Terminal
Fig. 53
33. Wire treatment
Fig. 51Panel Unit
NoteCore
CIS cable
Fusing section:
YWhen fixing the cable of the temperature fuse and the thermistor, put it
neat inside the projection of the frame.
If not, paper jams may be resulted.
Motor cable
Panel cableCore
Fig. 54
Fig. 52
3 � 26 |
ACEC
