FO-4450U/FO-CS1
6. Installing the paper cassette (FO-CS1)5Place the machine on top of the cassette.
1. Insert the cable guide into the cut-out in the edge of the metal
Installing the second paper cassetteplate, and then fold it in half and hook the top and bottom edges
Important: Be sure to turn off the power and unplug the power cordtogether.
before proceeding.2. Insert the 15pin cable through the ferrite core, and then connect
1Press the cover release to open the print compartment cover.the cable to the connectors on the machine and the cassette as
shown. Position the ferrite core in the gap between the bottom
left-hand corner of the circuit board and the side of the
compartment. Insert the cable into the cable guide, and then
insert the remainder of the cable into the slot in the cassette
below the cable guide. Tie the wires with the band.
2Remove 6 screws from the rear cover.
2
Remove the small cover on the left side of the rear cover, and then
remove the screw underneath. Remove the rear cover.
1
6Replace the small cover over the circuit board and secure it with a
10 mm screw.
3Remove 2 screws from the right cover of the machine.
From inside the print compartment, push the 3 tabs indicated in the
blowup out. (Note: The blowup shows the inside of the print compart-
ment.) Insert your left index finger in between the cover and the ma-
chine as shown, and then close the print compartment cover. With
your index finger still inserted, grasp both sides of the cover and pull
it off.
P
7Attach the support plates to the right side of the machine.
1. Remove the indicated screw.(In Step 8 below, replace it in the
same hole.)
2. Mount the large plate, making sure that the guides fit into the holes
as shown.
3. Mount the small plate, making sure that the guides fit into the holes
as shown.
4Remove the packing material and tape from the paper cassette.
1
A3
2
1 � 9 |
ACEC
