GX-CD30/30C/130/130C
FOR A COMPLETE DESCRIPTION OF THE OPERATION OF THIS UNIT, PLEASE REFER
TO THE OPERATION MANUAL.
IMPORTANT SERVICE NOTES (FOR GX-CD30/130 ONLY)
BEFORE RETURNING THE AUDIO PRODUCT
(Fire & Shock Hazard)
Before returning the audio product to the user, perform the
following safety checks.
1. Inspect all lead dress to make certain that leads are notVTVM
pinched or that hardware is not lodged between the chassisAC SCALE
and other metal parts in the audio product.
2. Inspect all protective devices such as insulating materials,
1.5k ohms
cabinet, terminal board, adjustment and compartment
10W
covers or shields, mechanical insulators etc.
3. To be sure that no shock hazard exists, check for leakage
current in the following manner.
* Plug the AC line cord directly into a 120 volt AC outlet.0.15 ? F
* Using two clip leads, connect a 1.5k ohm, 10 watt resistorTEST PROBECONNECT TO
paralleled by a 0.15mF capacitor in series with all exposedTO EXPOSED
KNOWN EARTH
metal cabinet parts and a known earth ground, such asMETAL PARTS
GROUND
conduit or electrical ground connected to earth ground.
* Use a VTVM or VOM with 1000 ohm per volt, or higher,
All check must be repeated with the AC line cord plug connection
sensitivity to measure the AC voltage drop across the
reversed.
resistor (See diagram).
Any reading of 0.3 volt RMS (this corresponds to 0.2 milliamp.
* Connect the resistor connection to all exposed metal parts
AC.) or more is excessive and indicates a potential shock
having a return path to the chassis (antenna, metal cabinet,
hazard which must be corrected before returning the audio
screw heads, knobs and control shafts, escutcheon, etc.)
product to the owner.
and measure the AC voltage drop across the resistor.
SPECIFICATIONS
l Generall Compact disc player
Power source:AC 120V, 60 HzDisc:Compact disc
DC 12 V [ "D" size (UM/SUM-1, R20Signal readout:Non-contact, 3-beam semi-
or HP-2) battery x 8]conductor laser pickup
Power consumption: 25 WAudio channels:2
Output power:FTC; 2.5 W minimum RMS perQuantization:16-bit linear
(30/130)channel into 6 ohms from 100 Hz toFilter:4-tims oversampling digital filter
20 kHz with no more than 10 % totalD/A converter:1-bit D/A converter
harmonic distortion.Wow and flutter:Unmeasurable
RMS; 3.5 W per channel at 1 kHz,(less than 0.001% W. peak)
10 % total harmonic distortion.
(AC operation)l Speaker
Output power:RMS; 7 W (3.5 W + 3.5 W)Type:2-way bass-reflex type
(30C/130C)(AC operation, 10 % T.H.D.)Speakers:4" (10 cm) woofer x 2
Output terminal:Headphones; 16 - 50 ohmsTweeter x 2
(recommended; 32 ohms)Maximum input power:5 W
Dimensions:Width; 12" (304 mm)Impedance:6 ohms
Height; 9-1/4" (234 mm)Dimensions:Width; 7-5/16" (185 mm)
Depth; 8-9/16" (216 mm)Height; 8-11/16" (220 mm)
Weight:7.1 Ibs. (3.2 kg) without batteriesDepth; 5-15/16" (150 mm)
Weight:2.2 Ibs. (1.0 kg) /each
l Radio
Frequency range:FM; 87.6 - 108 MHz
AM; 530 - 1,702 kHz
Specifications for this model are subject to change without
l Tape recorder
prior notice.
Frequency response:50 - 14,000 Hz (Normal tape)
Signal/noise ratio:50 dB (TAPE 1, recording / playback)
55 dB (TAPE 2, playback)
Wow and flitter:0.25 % (WRMS)
Motor:DC 12 V electric governor
Bias system:AC bias
Erase system:AC erase
� 2 � |
ACEC
