About power source3. Insert the 18-pin end of the supplied serial cable into the serial
?You can use two AA alkaline batteries or the optional NiMH Re-port on the unit.
chargeable Battery Pack to power your unit, or the AC adaptor
included in the optional Docking Station Kit.
?If the main batteries are not installed, or are depleted, the unit will
not function even when connected to an AC power source.
?Caution: When the main batteries are depleted, replace them
promptly with newteri bates. If the depleted main batteries are not
replaced, the backup battery will be drained more quickly than
normal, and data loss may occur after about 2 weeks.
??????
Important points to remember when installing new batteries:
?Be sure not to use any of the following as main batteries4.:I nmsaert the other end nga-of the cable into the serial port on your PC
nese batteries or nickel cadmium rechargeable batteries. Tthat hesyou sepecified during the Windows CE Services installation.
are easily mistaken for alkaline batteries.
?Do not remove the main batteries and the backup battery aUsitn gt thehe infrared port for file transfer
same time (this will result in the loss of all stored data).
You can use the built-in infrared port to transfer files with other hand-
?Backup important data before replacing batteries.held PCs compliant with the IrDA (115.2 kbps) standards.
?Replace both main batteries at the same time with new batMaterike seure s ofboth handheld PCs are turned on, then take the following
the same type.steps:
?When the main battery low warning message and the ba1c.kuAlpign the two handheld PCs so that their infrared ports are facing
battery low warning message appear at the same time, replaceea cthh other.e
backup battery first. After the backup battery replacement, turn on
your unit and make sure the backup battery low message is gone,
then you can proceed to replace the main batteries.
Caution:
?Keep batteries out of the reach of children.
?Danger of explosion if batteries are incorrectly replaced. Replace
only with the same or equivalent type recommended by the manu-
facturer. Discard used batteries according to the manufacturer?s
instructions.
?Backup battery: Replace battery wianasonith Pc type CR2032
only. Use of another battery may present a risk of fire of explosion.
See operation manual for safety instructions.
?Batteries may explode if mistreated. Do not recharge except the
optional NiMH Rechargeable Battery Pack, disassemble or dis-
pose of in fire.
Connecting the unit to your PC
You can connect the unit to your desktop PC to backup data, syn-
chronize activities, transfer files, etc.
Installing the Windows CE Services software2. From the sending unit, tap to select the file to transfer.
Before connecting the unit to a PC, you need to install the Window3. On the rseceiving uniReceit, tap ve from the Fil emenu, then spec-
CE Services software on your PC and specify a serial port ifor ufy the type of the sseending unit.
with the unit. Use the supplied CD-ROfrom MicM rosoffor t the instal-
lation.4. On the sending uniSent, dt fromap the Fil menu, eor tInapf rared
Recipien fromtSen d To of the Fil emenu. Specify the type of the
If this is the first time you are connecting the unit to your recPeCi,ving unit the Set, then start sending the data.
Up New Partner Wizard will appear on the PC. Follow the instructions
to complete the setup.
Connect the unit to the desktop PC as follows:
1. Turn on the unit.
2. Flip open the serial port cover and push it into the unit as shown.
- 37 - |
ACEC
