Section 1
Installation
1-1. Connecting the Extension Cable1-2. Attaching the Blank Panel
nm
Be sure to power off the VTR before following the steps. For details on removing the control panel from the VTR,
below.refer to O1-12. Removing/Reattaching Lower Control
Panel Unit� in the Installation Manual of the VTR.
1. Connect the extension cable (10 m) to the CONTROL. If the arm is not protruded, press the left and right unlock
PANEL connector at the rear or front.buttons, and after securing the arm to the 90d position
nfollowing the steps below.
If the extension cable is connected to the front-side
connector, remove the control panel unit. (Refer to the1. Place the blank panel with the squre holes of the panel
Installation Manual for the VTR.)aligned to the unlock buttons, slide it slightly to the
VTR to attach.
. Rear side connector2. Check that the screw holes visible from your side
before tightening the two screws.
Unlock button
Arm
Unlock button
CONTROL PANEL connector
. Front side connectorBVTT3 x 6
CONTROL PANEL connectorSquare hole
Cable holdersBlank panel
Square hole
BVTT3 x 6
Arm
3. Hold the blank panel as shown in the figures, and
while lifting the outer stays by the forefingers, close
the panel.
Turn off the power before
disconnecting the standard cable.m
. Make sure your finger does not get caught between
2. Connect the extension cable to the connector on thethe stays.
back side of the control panel unit, and fix the exten-. When connecting the extension cable to the front
sion cable in the cable holder.side connector, the cable can be run through the
3. Erect the feet, and then set the conrtol panel unit.clearance (about 10 mm) at the bottom even if the
blank panel is closed.
Extension cableBack view
Blank panel
ConnectorFoot
Cable holder
FootOuter stay
BKMW-1031-1 (E) |
ACEC
