1-3. Connection
1 ANALOG IN (analog signal input) connector (BNC type):
Received the analog composite video signal.
n
This connector is not received the black-and-white signal and signal with jitter.
2 Loop-through output connector (BNC type):
Provided the signal with supplied to ANALOG IN connector, just as it is.
If not used this connector, connect a 75-ohm terminator.
3 REF IN (reference signal input) connector (BNC type):
Received the analog black burst signal which will be the reference signal.
4 Loop-through output connector (BNC type):
Provided the signal with supplied to REF IN connector, just as it is.
If not used this connector, connect a 75-ohm terminator.
5 SDI OUT (digital signal output) connectors (BNC type):
Converted the signal with provided to the ANALOG IN connector to the 4:2:2 component serial
digital video signal.
The converted signal is synchronized with the reference signal which provided to REF IN connector
and is provided.
The same signals are provided from these connectors 1 to 4.
1-3-2. Connection Connector
If any cable is connected to the connectors on the connector panel when installing or servicing, use the
connector with listed below or equivalent.
BKPF-131BPMatching Connector/Cable
Panel IndicationConnectorConnector/CableSony Part No.
ANALOG INBNC (75W)BNC (75W)1-560-069-11
REF INBELDEN 8281 cable
SDI OUT 1-4
BKPF-131BP1-3 |
ACEC
