2. Information of BKSI-2030
2.Information of BKSI-2030Procedures
Flow for installation1. Turn the SIU-80 power off and remove the front panel
and shield plate.
Start
(Refer to the Installation Manual supplied with SIU-80.)
2. Insert the board into a slot, and then turn the board levers
Slot selectionin the direction of the arrow 1 and connect the board
securely to the connector of the SIU-80Os mother board.
Plug-in borad installation (DEC-79 board)
Model label attachment
Connector panel installation (IO-115 board)
EndPlug-in board
2-1.Plug-in Board Installation
2
1
General information for installation
SIU-80
Y The plug-in board (DEC-79 board) is inserted into any
slot No.1 to No.8 in the front of SIU-80.
Board leverBoard lever
For the number of maximum boards to be installed in
Install
SIU-80, refer to the Installation Manual supplied with11
22Remove
SIU-80.
Y The model label supplied with the board is attached to
the shield plate to prevent the board inserting into the3. Install the shield plate.
incorrect slot when the board replacement and others.Then, attach the model label supplied with the board
Y In the board replacing, set the setting of switches S3300on the right side of the shield plate.
and S3301 on a new board to the setting of the removedThis label position should be aligned with the slot
board.installing the board.
Y In the case of the board replacement in a live SIU-80,4. Install the front panel.
push the RESET switch (S3001) after the board is
inserted.
SIU-80
Model label
Shield plate
PSW 3X6
Front panel
n
When removing the board, turn the board levers in the
direction of the arrow 2, and pull the board out from
the slot.
1-4(E)BKSI-2030 |
ACEC
