Section 1
Service Overview
1-1. Location of Printed Circuit Boards1-3. Connector Input/Output Signals
VF (20P MALE)
VR-266 board
VF-67 board
(External view)
Pin No. SignalI/O Specifications
LP-101 board
1VTR SAVE IND INGND:Indicator lights
OPEN:Indicator goes out
2ABNORMAL IND INGND:Indicator lights
OPEN:Indicator goes out
1-2. Periodic Replacement Parts
316:9 MODEINGND:16:9
OPEN:4:3
Parts listed below are periodic replacement parts. They are
4REC (L) INDIN9 V:Indicator lights
subject to cracks with the lapse of time. Check sometimes
GND or OPEN:Indicator goes out
by visual, and replace as necessary.
5NC
6CCIR/EIAIN9.3 V:CCIR
GND:EIA
NameSony Part No.
7DISPLAYOUT ON:OPEN
Wind screen3-709-096-0X
OFF:GND
MIC cushion, rubber3-692-138-0X *1
8G TALLY IN 5 V:Indicator lights
Eye cup (S)3-723-079-0XGND or OPEN:Indicator goes out
9NC
10NC
11ZEBRAOUT ON:GND
Wind screen
OFF:5 V
Eye cup12VF VIDEO (X)IN1.0 V p-p
Zi = 75 W
13NC
14NC
Mic cushion, rubber15NC
16BATT INDIN5 V:Indicator lights
GND or OPEN:Indicator goes out
17TALLY INDIN9 V:Indicator lights
*1 It is recommended that the MIC cushions are replacedGND or OPEN:Indicator goes out
in pairs. In this case, please order two pieces.
18+ 9.3 V(VF)INREG + 9.3 V
19GNDGND
20NC
This unit normally operates with the above input signals.
Cameras described in this manual can output the signals
satisfying the specifications.
BVF-20W/20WCE1-1(E) |
ACEC
