SECTION 3
TEST MODE
ADJ MODEButtons and Corresponding Button Numbers
ButtonButton Number or Display
1. Chuck the CD first, and then turn OFF the power.
2. Short-circuit the test point (TP2:ADJ) of the main board andCONTINUE18
ground with a lead wire.SHUFFLE17
3. Press the 1/u button to turn ON the power.
PROGRAM16
The CD is played back automatically and the ADJ mode is set.
REPEAT9
4. To exit the mode, pr1/uess the button to turn OFF the power.
TIME/TEXT8
Y Prohibits high speed search during accessing
DISC CHECK30
Y Ignores even if GFS becomes L
DISC123
ADJ Mode Special Function TableDISC222
DISC321
ButtonFunction
DISC420
3Tracking servo, sled servo OFF
DISC519
8Tracking servo, sled servo ON
( (PLAY)Partial lighting 1 (Grid check)
P (PAUSE)28
FLUORESCENT INDICATOR TUBE, LED ALL LIT,p (STOP)Partial lighting 2 (Segment check)
AND KEY CHECK MODEEX-CHANGE24
DISC SKIP25
1. Short-circuit the test (TP1:AFADJ) of the main board and ground
¤ OPEN/CLOSEAll lit (LED lighting)
with a lead wire.
2. Press the 1/u button to turn ON the power.AMS ?30
The whole fluorescent indicator tube lights up.
AMS Â31
Nothing will be displayed when the SRAM is faulty or improperly
14
soldered.
3. All buttons have individual button numbers.23
When a button is pressed, the button number is counted up and
32
displayed.
41
50
615
10
714
Count up displayDisplays button number813
912
When remote controller signals are received, ORM **� will be
1011
displayed.
(** are the numbers corresponding to the remote controller keys.)>1010
When using the remote controller, switch the COMMAND MODE
switch to CD1.
4. To exit the mode, pr1/uess the button to turn OFF the po[MAIN BOwer.ARD] � CONDUCTOR SIDE �
IC501
R544
TP2
(ADJ)TP1
(AFADJ)
N 14 N |
ACEC
