CDP-CE275/CE375
Ver 1.1 2001.07
AGING MODE
For the aging mode, three modes of all mode, disc table mode, and loading mode are available.
This set has the Aging mode for operation check of the mechanism deck.
Y If a failure occurred
The aging operation stops and a faulty status is displayed on the fluorescent indicator tube.
Y If no failure occurs
The aging operation continues repeatedly.
Note:Do not use the test disc when performing aging.
Aging will not be performed properly if discs with tracks shorter than 4 seconds are used.
Procedure:
1. Press the [POWER] button and turn ON the power.
2. Set discs on all trays.
(More than two discs if five are not available)
3. All mode:
Press the [CHECK], [PLAY MODE] andx buttons at the same time.
Disc table mode:
Press the [CHECK], [PLAY MODE] and [SKIP] buttons at the same time.
Loading mode:
Press the [CHECK], [PLAY MODE] and [EX-CHANGE] buttons at the same time.
4. Aging starts, and the fluorescent indicator tube will display the following.
5. To exit the mode, pr[POWER]ess the button to turn OFF the power.
Disc tableLoadingDisplay inDisplay in
Code No. StatusAll mode
modemodeNormal operationcase of failure
0CLOSE (Tray closed)aaA-0Err 0
1TOC readingaaaA-1Err 1
2Access to last trackaA-2Err 2
3Play of last track (3 sec)aCounter displayErr 3
4EX OPEN (Tray opened while chucking)aaA-4Err 4
5EX SKIP (Disc tray rotated)aA-5Err 5
6EX CLOSE (Tray closed)aaA-6Err 6
7Access to first trackaA-7Err 7
8Play of first track (3 sec)aCounter displayErr 8
9OPEN (tray opened)aaA-9Err 9
DISC SKIP (Disc tray rotated,
AaaA-AErr A
and next disc was selected)
The discs are selectie in the order of DISC1 ? DISC2 ? DISC3 ? DISC4 ? DISC5 ? DISC1 ? .... Empty trays are skipped.
But the order is random in the disc table mode.
MECHANISM DECK CHECK MODE
For the mechanism deck check mode, two modes of disc table mode and loading mode are available.
In the mechanism deck check mode, the disc table turning time and the loading time in each section are measured and displayed.
Procedure:
Disc table mode:
Press the [POWER] switch while pressingH , [ OPEN/CLOSE]A and [REPEAT] buttons simultaneously.
Loading mode:
Press the [POWER] switch while pressingH , [ OPEN/CLOSE]A and [TIME] buttons simultaneously.
Display contents
ModeCheck commandDisplay
Disc table mode0: Right one turnr 12.5
Table turning1: Left one TurnL 10.2
( time measurement )
2: Measurement endr 12.5
3: Undefined
4: Star position� �Sta.�
5: Open ? CloseCLo 10.2
6: Close ? BU upUP0.7
Table mode
7: BU up ? EX openEoP6.2
Loading time
8: EX open ? EX closeECL 10.3
( measurement )
9: EX close ? BU downdon1.2
A: BU down ? OpenoPn9.3
FF: Measurement endCLo 10.2
12 |
ACEC
